Searched +full:0 +full:xe0100000 (Results 1 – 18 of 18) sorted by relevance
/freebsd/sys/contrib/device-tree/Bindings/crypto/ |
H A D | amd-ccp.txt | 14 reg = <0 0xe0100000 0 0x10000>; 16 interrupts = <0 3 4>;
|
/freebsd/sys/contrib/device-tree/Bindings/gpio/ |
H A D | wd,mbl-gpio.txt | 15 0 = active high 26 reg = <0xe0000000 0x1>; 34 reg = <0xe0100000 0x1>;
|
H A D | gpio-mmio.yaml | 40 of GPIOs is set by the width, with bit 0 corresponding to GPIO 0. 54 actively writing the line with 0. 95 reg = <0x1f300010 0x4>; 104 reg = <0xe0100000 0x1>; 113 reg = <0xfffe0406 2>, <0xfffe040a 2>;
|
/freebsd/sys/contrib/device-tree/Bindings/clock/ |
H A D | samsung,s5pv210-clock.yaml | 59 xxti: clock-0 { 61 clock-frequency = <0>; 63 #clock-cells = <0>; 68 clock-frequency = <0>; 70 #clock-cells = <0>; 75 reg = <0xe0100000 0x10000>;
|
/freebsd/sys/contrib/device-tree/src/nds32/ |
H A D | ae3xx.dts | 12 memory@0 { 14 reg = <0x00000000 0x40000000>; 19 #size-cells = <0>; 20 cpu@0 { 23 reg = <0>; 36 #clock-cells = <0>; 49 reg = <0xf0300000 0x1000>; 59 reg = <0xf0400000 0x1000>; 74 reg = <0xe0500000 0x1000>; 81 reg = <0xe0100000 0x1000>;
|
/freebsd/sys/contrib/device-tree/src/powerpc/ |
H A D | mpc832x_rdb.dts | 26 #size-cells = <0>; 28 PowerPC,8323@0 { 30 reg = <0x0>; 31 d-cache-line-size = <0x20>; // 32 bytes 32 i-cache-line-size = <0x20>; // 32 bytes 35 timebase-frequency = <0>; 36 bus-frequency = <0>; 37 clock-frequency = <0>; 43 reg = <0x00000000 0x04000000>; 51 ranges = <0x0 0xe0000000 0x00100000>; [all …]
|
H A D | mpc832x_mds.dts | 39 #size-cells = <0>; 41 PowerPC,8323@0 { 43 reg = <0x0>; 48 timebase-frequency = <0>; 49 bus-frequency = <0>; 50 clock-frequency = <0>; 56 reg = <0x00000000 0x08000000>; 61 reg = <0xf8000000 0x8000>; 69 ranges = <0x0 0xe0000000 0x00100000>; 70 reg = <0xe0000000 0x00000200>; [all …]
|
H A D | mpc836x_mds.dts | 31 #size-cells = <0>; 33 PowerPC,8360@0 { 35 reg = <0x0>; 48 reg = <0x00000000 0x10000000>; 56 reg = <0xe0005000 0xd8>; 57 ranges = <0 0 0xfe000000 0x02000000 58 1 0 0xf8000000 0x00008000>; 60 flash@0,0 { 62 reg = <0 0 0x2000000>; 67 bcsr@1,0 { [all …]
|
H A D | ac14xx.dts | 25 PowerPC,5121@0 { 33 reg = <0x00000000 0x10000000>; /* 256MB at 0 */ 41 ranges = <0x0 0x0 0xfc000000 0x04000000 /* CS0: NOR flash */ 42 0x1 0x0 0xe0000000 0x00010000 /* CS1: FRAM */ 43 0x2 0x0 0xe0100000 0x00080000 /* CS2: asi1 */ 44 0x3 0x0 0xe0300000 0x00020000 /* CS3: comm */ 45 0x5 0x0 0xe0400000 0x00010000 /* CS5: safety */ 46 0x6 0x0 0xe0200000 0x00080000>; /* CS6: asi2 */ 48 flash@0,0 { 50 reg = <0 0x00000000 0x04000000>; [all …]
|
H A D | sequoia.dts | 22 dcr-parent = <&{/cpus/cpu@0}>; 35 #size-cells = <0>; 37 cpu@0 { 40 reg = <0x00000000>; 41 clock-frequency = <0>; /* Filled in by zImage */ 42 timebase-frequency = <0>; /* Filled in by zImage */ 54 reg = <0x00000000 0x00000000 0x00000000>; /* Filled in by zImage */ 60 cell-index = <0>; 61 dcr-reg = <0x0c0 0x009>; 62 #address-cells = <0>; [all …]
|
/freebsd/sys/contrib/device-tree/Bindings/spi/ |
H A D | spi-pl022.yaml | 47 runtime power management system suspends the device. A setting of 0 88 reg = <0xe0100000 0x1000>; 90 #size-cells = <0>; 91 interrupts = <0 31 0x4>; 93 <&dma_controller 24 0>; 102 pl022,interface = <0>; 103 pl022,com-mode = <0x [all...] |
/freebsd/sys/contrib/device-tree/src/arm/st/ |
H A D | spear13xx.dtsi | 15 #size-cells = <0>; 17 cpu@0 { 20 reg = <0>; 36 reg = < 0xec801000 0x1000 >, 37 < 0xec800100 0x0100 >; 42 interrupts = <0 6 0x04>, 43 <0 [all...] |
/freebsd/sys/contrib/device-tree/Bindings/mmc/ |
H A D | arasan,sdhci.txt | 55 - #clock-cells: If specified this should be the value <0> or <1>. With this 66 will assume this as 0. 71 reg = <0xe0100000 0x1000>; 75 interrupts = <0 24 4>; 80 reg = <0xe2800000 0x1000>; 84 interrupts = <0 24 4>; 91 reg = <0x0 0xfe330000 0x0 0x10000>; 101 #clock-cells = <0>; 107 interrupts = <0 48 4>; 108 reg = <0x0 0xff160000 0x0 0x1000>; [all …]
|
H A D | arasan,sdhci.yaml | 137 enum: [0, 1] 158 enum: [0, 1, 2] 159 default: 0 185 reg = <0xe0100000 0x1000>; 189 interrupts = <0 24 4>; 195 reg = <0xe2800000 0x1000>; 199 interrupts = <0 2 [all...] |
/freebsd/sys/contrib/device-tree/src/arm64/amd/ |
H A D | amd-seattle-soc.dtsi | 20 reg = <0x0 0xe1110000 0 0x1000>, 21 <0x0 0xe112f000 0 0x2000>, 22 <0x0 0xe1140000 0 0x2000>, 23 <0x0 0xe1160000 0 0x2000>; 24 interrupts = <1 9 0xf04>; 25 ranges = <0 0 0 0xe1100000 0 0x100000>; 29 reg = <0x0 0x00080000 0 0x1000>; 35 interrupts = <1 13 0xff04>, 36 <1 14 0xff04>, 37 <1 11 0xff04>, [all …]
|
/freebsd/sys/contrib/device-tree/src/arm/xilinx/ |
H A D | zynq-7000.dtsi | 13 #size-cells = <0>; 15 cpu0: cpu@0 { 18 reg = <0>; 47 interrupts = <0 5 4>, <0 6 4>; 49 reg = <0xf8891000 0x1000>, 50 <0xf8893000 0x1000>; 69 #size-cells = <0>; 72 port@0 { 73 reg = <0>; 104 reg = <0xf8007100 0x20>; [all …]
|
/freebsd/sys/contrib/device-tree/src/arm/samsung/ |
H A D | s5pv210.dtsi | 46 #size-cells = <0>; 48 cpu@0 { 51 reg = <0>; 55 xxti: oscillator-0 { 57 clock-frequency = <0>; 59 #clock-cells = <0>; 64 clock-frequency = <0>; 66 #clock-cells = <0>; 77 reg = <0xb0600000 0x200 [all...] |
/freebsd/tools/test/iconv/ref/ |
H A D | UTF-32BE-rev | 1 0x00 = 0x00000000 2 0x01 = 0x01000000 3 0x02 = 0x02000000 4 0x03 = 0x03000000 5 0x04 = 0x04000000 6 0x05 = 0x05000000 7 0x06 = 0x06000000 8 0x07 = 0x07000000 9 0x08 = 0x08000000 10 0x09 = 0x09000000 [all …]
|