| /linux/Documentation/devicetree/bindings/phy/ |
| H A D | amlogic,g12a-usb3-pcie-phy.yaml | 58 reg = <0x46000 0x2000>;
|
| /linux/drivers/gpu/drm/msm/disp/mdp5/ |
| H A D | mdp5_cfg.c | 22 0,
35 .base = { 0x00500, 0x00600, 0x00700, 0x00800, 0x00900 },
36 .flush_hw_mask = 0x0003ffff,
40 .base = { 0x01100, 0x01500, 0x01900 },
45 0,
49 .base = { 0x01d00, 0x02100, 0x02500 },
53 0,
57 .base = { 0x02900, 0x02d00 },
60 0,
64 .base = { 0x03100, 0x03500, 0x03900, 0x03d00, 0x04100 },
[all …]
|
| /linux/drivers/gpu/drm/i915/display/ |
| H A D | intel_fdi_regs.h | 11 #define FDI_PLL_BIOS_0 _MMIO(0x46000)
12 #define FDI_PLL_FB_CLOCK_MASK 0xff
13 #define FDI_PLL_BIOS_1 _MMIO(0x46004)
14 #define FDI_PLL_BIOS_2 _MMIO(0x46008)
15 #define DISPLAY_PORT_PLL_BIOS_0 _MMIO(0x4600c)
16 #define DISPLAY_PORT_PLL_BIOS_1 _MMIO(0x46010)
17 #define DISPLAY_PORT_PLL_BIOS_2 _MMIO(0x46014)
19 #define FDI_PLL_FREQ_CTL _MMIO(0x46030)
21 #define FDI_PLL_FREQ_LOCK_LIMIT_MASK 0xfff00
22 #define FDI_PLL_FREQ_DISABLE_COUNT_LIMIT_MASK 0xff
[all …]
|
| /linux/drivers/gpu/drm/amd/include/asic_reg/athub/ |
| H A D | athub_1_8_0_offset.h | 29 // base address: 0x3080
30 …ATC_ATS_CNTL 0x0000
31 …e regATC_ATS_CNTL_BASE_IDX 0
32 …ATC_ATS_CNTL2 0x0001
33 …e regATC_ATS_CNTL2_BASE_IDX 0
34 …ATC_ATS_CNTL3 0x0002
35 …e regATC_ATS_CNTL3_BASE_IDX 0
36 …ATC_ATS_CNTL4 0x0003
37 …e regATC_ATS_CNTL4_BASE_IDX 0
38 …ATC_ATS_MISC_CNTL 0x0005
[all …]
|
| /linux/arch/powerpc/boot/dts/fsl/ |
| H A D | p4080si-post.dtsi | 37 alloc-ranges = <0 0 0x10 0>;
42 alloc-ranges = <0 0 0x10 0>;
47 alloc-ranges = <0 0 0x10 0>;
52 interrupts = <25 2 0 0>;
57 /* controller at 0x200000 */
63 bus-range = <0x0 0xff>;
67 fsl,liodn-reg = <&guts 0x500>; /* PEX1LIODNR */
68 pcie@0 {
69 reg = <0 0 0 0 0>;
75 interrupt-map-mask = <0xf800 0 0 7>;
[all …]
|
| /linux/drivers/gpu/drm/amd/include/asic_reg/vpe/ |
| H A D | vpe_6_1_0_offset.h | 29 // base address: 0x46000
30 …VPEC_DEC_START 0x0000
31 …e regVPEC_DEC_START_BASE_IDX 0
32 …VPEC_UCODE_ADDR 0x0001
33 …e regVPEC_UCODE_ADDR_BASE_IDX 0
34 …VPEC_UCODE_DATA 0x0002
35 …e regVPEC_UCODE_DATA_BASE_IDX 0
36 …VPEC_F32_CNTL 0x0003
37 …e regVPEC_F32_CNTL_BASE_IDX 0
38 …VPEC_VPEP_CTRL 0x0010
[all …]
|
| /linux/drivers/net/ethernet/marvell/octeontx2/af/ |
| H A D | rvu_reg.h | 12 #define RVU_AF_MSIXTR_BASE (0x10)
13 #define RVU_AF_ECO (0x20)
14 #define RVU_AF_BLK_RST (0x30)
15 #define RVU_AF_PF_BAR4_ADDR (0x40)
16 #define RVU_AF_RAS (0x100)
17 #define RVU_AF_RAS_W1S (0x108)
18 #define RVU_AF_RAS_ENA_W1S (0x110)
19 #define RVU_AF_RAS_ENA_W1C (0x118)
20 #define RVU_AF_GEN_INT (0x120)
21 #define RVU_AF_GEN_INT_W1S (0x128)
[all …]
|
| /linux/drivers/soc/tegra/cbb/ |
| H A D | tegra234-cbb.c | 8 * Error types supported by CBB2.0 are:
27 #define FABRIC_EN_CFG_INTERRUPT_ENABLE_0_0 0x0
28 #define FABRIC_EN_CFG_STATUS_0_0 0x40
29 #define FABRIC_EN_CFG_ADDR_INDEX_0_0 0x60
30 #define FABRIC_EN_CFG_ADDR_LOW_0 0x80
31 #define FABRIC_EN_CFG_ADDR_HI_0 0x84
33 #define FABRIC_EN_CFG_TARGET_NODE_ADDR_INDEX_0_0 0x100
34 #define FABRIC_EN_CFG_TARGET_NODE_ADDR_LOW_0 0x140
35 #define FABRIC_EN_CFG_TARGET_NODE_ADDR_HI_0 0x144
37 #define FABRIC_MN_INITIATOR_ERR_EN_0 0x200
[all …]
|
| /linux/arch/arm64/boot/dts/amlogic/ |
| H A D | meson-g12-common.dtsi | 107 reg = <0x0 0x05000000 0x0 0x300000>;
113 reg = <0x0 0x05300000 0x0 0x2000000>;
120 size = <0x0 0x10000000>;
121 alignment = <0x0 0x400000>;
138 reg = <0x0 0xfc000000 0x0 0x400000>,
139 <0x0 0xff648000 0x0 0x2000>,
140 <0x0 0xfc400000 0x0 0x200000>;
144 interrupt-map-mask = <0 0 0 0>;
145 interrupt-map = <0 0 0 0 &gic GIC_SPI 223 IRQ_TYPE_LEVEL_HIGH>;
146 bus-range = <0x0 0xff>;
[all …]
|
| /linux/drivers/clk/qcom/ |
| H A D | gcc-msm8909.c | 52 { P_XO, 0 },
64 .offset = 0x21000,
67 .enable_reg = 0x45000,
68 .enable_mask = BIT(0),
80 .offset = 0x21000,
94 .l_reg = 0x20004,
95 .m_reg = 0x20008,
96 .n_reg = 0x2000c,
97 .config_reg = 0x20010,
98 .mode_reg = 0x20000,
[all …]
|
| H A D | gcc-qcs404.c | 49 { P_XO, 0 },
68 .offset = 0x21000,
71 .enable_reg = 0x45008,
84 .offset = 0x21000,
88 .enable_reg = 0x45000,
89 .enable_mask = BIT(0),
100 .offset = 0x21000,
104 .enable_reg = 0x45000,
105 .enable_mask = BIT(0),
117 .offset = 0x20000,
[all …]
|
| H A D | gcc-msm8916.c | 45 .l_reg = 0x21004,
46 .m_reg = 0x21008,
47 .n_reg = 0x2100c,
48 .config_reg = 0x21010,
49 .mode_reg = 0x21000,
50 .status_reg = 0x2101c,
63 .enable_reg = 0x45000,
64 .enable_mask = BIT(0),
76 .l_reg = 0x20004,
77 .m_reg = 0x20008,
[all …]
|
| H A D | gcc-msm8917.c | 58 .offset = 0x21000,
61 .enable_reg = 0x45008,
76 .offset = 0x21000,
79 .enable_reg = 0x45000,
80 .enable_mask = BIT(0),
93 .offset = 0x21000,
106 { 700000000, 1400000000, 0 },
110 { 525000000, 1066000000, 0 },
115 .config_ctl_val = 0x4001055b,
116 .early_output_mask = 0,
[all …]
|
| H A D | gcc-msm8976.c | 56 .l_reg = 0x21004,
57 .m_reg = 0x21008,
58 .n_reg = 0x2100c,
59 .config_reg = 0x21014,
60 .mode_reg = 0x21000,
61 .status_reg = 0x2101c,
74 .enable_reg = 0x45000,
75 .enable_mask = BIT(0),
89 .l_reg = 0x4a004,
90 .m_reg = 0x4a008,
[all …]
|
| H A D | gcc-msm8939.c | 53 .l_reg = 0x21004,
54 .m_reg = 0x21008,
55 .n_reg = 0x2100c,
56 .config_reg = 0x21010,
57 .mode_reg = 0x21000,
58 .status_reg = 0x2101c,
71 .enable_reg = 0x45000,
72 .enable_mask = BIT(0),
84 .l_reg = 0x20004,
85 .m_reg = 0x20008,
[all …]
|
| H A D | gcc-ipq6018.c | 50 .offset = 0x21000,
53 .enable_reg = 0x0b000,
54 .enable_mask = BIT(0),
79 .offset = 0x21000,
98 { P_XO, 0 },
104 .offset = 0x25000,
108 .enable_reg = 0x0b000,
122 .offset = 0x25000,
136 .offset = 0x37000,
139 .enable_reg = 0x0b000,
[all …]
|