Home
last modified time | relevance | path

Searched +full:0 +full:x02184400 (Results 1 – 5 of 5) sorted by relevance

/freebsd/sys/contrib/device-tree/Bindings/usb/
H A Dchipidea,usb2-imx.yaml103 pins after a J-to-K or K-to-J transition. The range is from 0x0 to
104 0x3, the default value is 0x1. Details can refer to TXPREEMPAMPTUNE0
107 minimum: 0x0
108 maximum: 0x3
113 level voltage. The range is from 0x0 to 0xf, the default value is
114 0x3. Details can refer to TXVREFTUNE0 bits of USBNC_n_PHY_CFG1.
116 minimum: 0x0
117 maximum: 0xf
124 to design default time. (0:-10%; 1:design default; 2:+15%; 3:+20%)
127 minimum: 0
[all …]
H A Dci-hdrc-usb2.txt46 aligned with AHBBRST at SBUSCFG, the range is from 0x0 to 0x7. This
54 "ahb-burst-config" is set to 0, if this property is missing the reset
60 "ahb-burst-config" is set to 0, if this property is missing the reset
65 of the external connector devices is not required, empty <0> phandle should
70 ttctrl.ttha will be 0x7f; if not, the value will be 0x0, this is the default
73 On the most of chipidea platforms, the "usage_tt" flag at RTL is 0, so this
86 controller. It's expected that a mux state of 0 indicates device mode and a
107 The range is from 0x0 to 0x3, the default value is 0x1.
111 The range is from 0x0 to 0xf, the default value is 0x3.
118 reg = <0xf7ed0000 0x10000>;
[all …]
/freebsd/sys/contrib/device-tree/src/arm/nxp/imx/
H A Dimx6sl.dtsi51 #size-cells = <0>;
53 cpu0: cpu@0 {
56 reg = <0x0>;
86 #clock-cells = <0>;
92 #clock-cells = <0>;
100 interrupts = <0 94 IRQ_TYPE_LEVEL_HIGH>;
105 #phy-cells = <0>;
117 reg = <0x00900000 0x20000>;
118 ranges = <0 0x00900000 0x20000>;
128 reg = <0x00a01000 0x1000>,
[all …]
H A Dimx6qdl.dtsi59 #clock-cells = <0>;
65 #clock-cells = <0>;
66 clock-frequency = <0>;
71 #clock-cells = <0>;
78 #size-cells = <0>;
83 lvds-channel@0 {
85 #size-cells = <0>;
86 reg = <0>;
89 port@0 {
90 reg = <0>;
[all …]
H A Dimx6sx.dtsi61 #size-cells = <0>;
63 cpu0: cpu@0 {
66 reg = <0>;
100 #clock-cells = <0>;
107 #clock-cells = <0>;
114 #clock-cells = <0>;
115 clock-frequency = <0>;
121 #clock-cells = <0>;
122 clock-frequency = <0>;
128 #clock-cells = <0>;
[all …]