xref: /illumos-gate/usr/src/uts/sun4u/daktari/sys/hpc3130_dak.h (revision 7c478bd95313f5f23a4c958a745db2134aa03244)
1 /*
2  * CDDL HEADER START
3  *
4  * The contents of this file are subject to the terms of the
5  * Common Development and Distribution License, Version 1.0 only
6  * (the "License").  You may not use this file except in compliance
7  * with the License.
8  *
9  * You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE
10  * or http://www.opensolaris.org/os/licensing.
11  * See the License for the specific language governing permissions
12  * and limitations under the License.
13  *
14  * When distributing Covered Code, include this CDDL HEADER in each
15  * file and include the License file at usr/src/OPENSOLARIS.LICENSE.
16  * If applicable, add the following below this CDDL HEADER, with the
17  * fields enclosed by brackets "[]" replaced with your own identifying
18  * information: Portions Copyright [yyyy] [name of copyright owner]
19  *
20  * CDDL HEADER END
21  */
22 /*
23  * Copyright 2000-2001, 2003 Sun Microsystems, Inc.  All rights reserved.
24  * Use is subject to license terms.
25  */
26 
27 #ifndef	_SYS_HPC3130_DAK_H
28 #define	_SYS_HPC3130_DAK_H
29 
30 #pragma ident	"%Z%%M%	%I%	%E% SMI"
31 
32 #ifdef	__cplusplus
33 extern "C" {
34 #endif
35 
36 #if defined(_KERNEL)
37 
38 #include <sys/i2c/clients/i2c_client.h>
39 
40 /* masks */
41 
42 #define	HPC3130_PROTECT_ON 0x01 /* (R/W) protection enable mechanism */
43 #define	HPC3130_SYSM66STAT 0x02 /* (R) indicates bus runs at 66Mhz */
44 #define	HPC3130_SEQUENCING 0x0c /* (R/W) hotplug sequencing mode */
45 #define	HPC3130_MANUAL_SEQ 0x00 /* controle with idividual register calls */
46 #define	HPC3130_AUTO1_SEQ  0x04 /* enable CBT before disable RST# */
47 #define	HPC3130_AUTO2_SEQ  0x08 /* enable CBT after disable RST# */
48 
49 #define	HPC3130_GCR		0x00
50 #define	HPC3130_STATUS		0x01
51 #define	HPC3130_CONTROL		0x02
52 #define	HPC3130_ATTEN		0x03
53 #define	HPC3130_EVENT_STATUS	0x06
54 #define	HPC3130_INTERRUPT	0x07
55 #define	HPC3130_NO_REGISTER	0xff
56 
57 /*
58  * masks
59  */
60 #define	HPC3130_PRSNT1   0x01 /* (R) Logic level of PRSNT1# signal */
61 #define	HPC3130_PRSNT2   0x02 /* (R) Logic level of PRSNT2# signal */
62 #define	HPC3130_DETECT0  0x04 /* (R) Logic level of DETECT0# signal */
63 #define	HPC3130_DETECT1  0x08 /* (R) Logic level of DETECT1# signal */
64 #define	HPC3130_PWRFAULT 0x10 /* (R) Logic level of PWRFAULT# signal */
65 #define	HPC3130_PWRGOOD  0x20 /* (R) Logic level of PWRGOOD# signal */
66 #define	HPC3130_M66EN    0x40 /* (R) Logic level of M66EN terminal */
67 #define	HPC3130_BUSON    0x80 /* (R) Logic level of BUSON# signal */
68 
69 
70 /*
71  * more masks
72  */
73 /* (R/W) Logical level of SLOTRST# (used to reset a slot) */
74 #define	HPC3130_SLOTRST		0x01
75 /* (R/W) Logical level of CLKON# (used to control clock signal) */
76 #define	HPC3130_CLKON		0x02
77 /* (R/W) Logical level of REQ64ON# signal */
78 #define	HPC3130_REQ64		0x04
79 /* (R/W) Logical level of SLOTREQ64# signal */
80 #define	HPC3130_SLOTREQ64	0x08
81 /* (R/W) Bus control (for auto sequence level==1?disconnect:connect */
82 #define	HPC3130_BUS_CTL		0x10
83 /* (R/W) Logical level of power control on the slot */
84 #define	HPC3130_SLTPWRCTL	0x20
85 
86 
87 #define	HPC3130_ATTN0		0x00
88 #define	HPC3130_ATTN1		0x01
89 
90 #define	HPC3130_LED_FAULT	HPC3130_ATTN1
91 #define	HPC3130_LED_OK2REM	HPC3130_ATTN0
92 
93 #define	HPC3130_ATTN_MASK(led)	(3<<(HPC3130_ATTN_SHIFT(led)))	/* 3 or c */
94 #define	HPC3130_ATTN_SHIFT(led)	(led<<1)			/* 0 or 2 */
95 
96 #define	HPC3130_ATTN_OFF	0x00
97 #define	HPC3130_ATTN_SLO	0x01 		/* not used by Daktari */
98 #define	HPC3130_ATTN_FST	0x02
99 #define	HPC3130_ATTN_ON		0x03
100 
101 /*
102  * These two macros map between the Hot Plug Services LED constants
103  * (cf. uts/common/sys/hotplug/hpctrl.h) and the values used by the
104  * HPC3130 hardware.
105  */
106 
107 static char hpc3130_to_hpc_led_map[] = {
108 	HPC_LED_OFF, HPC_LED_BLINK, HPC_LED_BLINK, HPC_LED_ON
109 };
110 static char hpc3130_from_hpc_led_map[] = {
111 	HPC3130_ATTN_OFF, HPC3130_ATTN_ON, HPC3130_ATTN_FST
112 };
113 #define	HPC3130_TO_HPC_LED(val)		(hpc3130_to_hpc_led_map[val])
114 #define	HPC3130_FROM_HPC_LED(val)	(hpc3130_from_hpc_led_map[val])
115 
116 #define	HPC3130_MAX_SLOT	0x4
117 
118 #define	HPC3130_TABLE_COLUMNS	3 /* number of colums in slot-table property */
119 #define	HPC3130_DEBOUNCE_COUNT	2 /* consecutive equal readings == debounced */
120 #define	HPC3130_DEBOUNCE_LIMIT	1000 /* hard upper limit on debouce code */
121 #define	HPC3130_POWER_TRIES	3 /* Try this may times to connect/disconnect */
122 #define	HPC3130_ADEQUATE_PAUSE	25000 /* usec delay for connect sequence */
123 
124 /*
125  * This structure defines an element of the controller's
126  * slot table array
127  */
128 
129 typedef struct hpc3130_slot_table_entry hpc3130_slot_table_entry_t;
130 typedef struct hpc3130_callback_arg hpc3130_callback_arg_t;
131 
132 struct hpc3130_callback_arg {
133 	caddr_t		handle;
134 	caddr_t		statep;
135 	uint8_t		offset;
136 };
137 
138 struct hpc3130_slot_table_entry {
139 	hpc_slot_info_t		hpc3130_slot_info;
140 	hpc_slot_t		hpc3130_slot_handle;
141 	char			nexus[MAXNAMELEN];
142 	hpc3130_callback_arg_t	callback_info;
143 };
144 
145 /*
146  * The soft state structure
147  */
148 struct hpc3130_unit {
149 
150 	dev_info_t *dip;
151 
152 	hpc_slot_ops_t *hpc3130_slot_ops;
153 
154 	/*
155 	 * the following fields hold the value of the "slot-table"
156 	 * property for this controller
157 	 */
158 	caddr_t hpc3130_slot_table_data;
159 	int hpc3130_slot_table_size;
160 
161 	/*
162 	 * the following fields represent the array of hot-plug
163 	 * slots derived from the "slot-table" property
164 	 */
165 	hpc3130_slot_table_entry_t *hpc3130_slot_table;
166 	int hpc3130_slot_table_length;
167 
168 	/*
169 	 * Mutex associated with this structure
170 	 */
171 	kmutex_t hpc3130_mutex;
172 
173 	/*
174 	 * Trap interrupt cookie
175 	 */
176 	ddi_iblock_cookie_t ic_trap_cookie;
177 
178 	/*
179 	 * Open flag
180 	 */
181 	int hpc3130_oflag;
182 
183 	/*
184 	 * An integer field describing the type
185 	 * of slots (PCI/SBD).
186 	 */
187 	hpc3130_slot_type_t slots_are;
188 
189 	/*
190 	 * A place to put the name of this driver
191 	 * What gets put here is "hpc3130n" - where
192 	 * n is the instance number.
193 	 */
194 	char hpc3130_name[16];
195 
196 	/*
197 	 * The handle within the I2C nexus that this instance
198 	 * represents.
199 	 */
200 	i2c_client_hdl_t hpc3130_hdl;
201 
202 	/*
203 	 * condition variable used to throttle power OK signal
204 	 */
205 	kcondvar_t hpc3130_cond;
206 
207 	/*
208 	 * Present vector - if B_TRUE there is a card in the corresponding
209 	 * slot.
210 	 */
211 	boolean_t present[HPC3130_MAX_SLOT];
212 
213 	/*
214 	 * Power vector - if B_TRUE, then power is applied to the slot
215 	 */
216 	boolean_t power[HPC3130_MAX_SLOT];
217 
218 	/*
219 	 * Enable vector - if B_TRUE the slot is enabled.
220 	 */
221 	boolean_t enabled[HPC3130_MAX_SLOT];
222 
223 	/*
224 	 * LED state indicators.
225 	 */
226 	char fault_led[HPC3130_MAX_SLOT];
227 	char ok2rem_led[HPC3130_MAX_SLOT];
228 
229 	/* For poll(9e)/ioctl(HPC3130_GET_SOFT_EVENT */
230 	uint_t events[HPC3130_MAX_SLOT];
231 	pollhead_t pollhead[HPC3130_MAX_SLOT];
232 };
233 
234 typedef struct hpc3130_unit hpc3130_unit_t;
235 
236 #endif	/* _KERNEL */
237 
238 #ifdef	__cplusplus
239 }
240 #endif
241 
242 #endif	/* _SYS_HPC3130_DAK_H */
243