Lines Matching +full:partition +full:-
8 ssd \- Fibre Channel Arbitrated Loop disk device driver
27 The block-files access the disk using the system's normal buffering mechanism
42 Partition 0 is normally used for the root file system on a disk, with partition
43 1 as a paging area (for example, \fBswap\fR). Partition 2 is used to back up
44 the entire disk. Partition 2 normally maps the entire disk and may also be used
46 normally partition 6. For the primary disk, the user file system is located
57 for that device. For each device/partition, the driver accumulates reads,
58 writes, bytes read, and bytes written. The driver also initiates hi-resolution
60 time and cumulative residence-length product for each queue.
63 Not all device drivers make per-partition IO statistics available for
64 reporting. \fBssd\fR and \fBsd\fR(7D) per-partition statistics are enabled by
86 The partition was opened exclusively by another thread.
141 The device is a read-only device.
152 \fB\fBenable-partition-kstats\fR\fR
155 The default value is 1, which causes partition IO statistics to be maintained.
156 Set this value to zero to prevent the driver from recording partition
159 reporting by \fBiostat\fR(1M) even though the \fB-p\fR/\fB-P\fR option is
166 In addition to the above properties, some device-specific tunables can be
167 configured in \fBssd.conf\fR using the 'ssd-config-list' global property. The
172 ssd-config-list = <duplet> [, <duplet> ]* ;
176 <duplet>:= "<vid+pid>" , "<tunable-list>"
180 <tunable-list>:= <tunable> [, <tunable> ]*;
186 The <tunable-list> contains one or more tunables to apply to
192 delay-busy: when busy, nsecs of delay before retry.
194 retries-timeout: retries to perform on an IO timeout.
196 .in -2
202 The following is an example of a global ssd-config-list property:
204 ssd-config-list =
205 "SUN T4", "delay-busy:600, retries-timeout:6",
206 "SUN StorEdge_3510", "retries-timeout:3";
208 .in -2
253 7-bit disk loop identifier, such as switch setting
271 partition \fIn\fR (0-7)
282 \fIANSI Small Computer System Interface-2 (SCSI-2)\fR
285 \fIANSI X3.272-1996, Fibre Channel Arbitrated Loop (FC-AL)\fR
288 \fIFibre Channel - Private Loop SCSI Direct Attach (FC-PLDA)\fR
297 .in -2
311 .in -2
323 .in -2
335 .in -2
346 .in -2
357 .in -2
368 .in -2
381 .in -2
392 .in -2
401 corrupt label - bad geometry
403 .in -2
412 corrupt label - label checksum failed
414 .in -2
423 corrupt label - wrong magic number
425 .in -2
436 .in -2
447 .in -2
458 .in -2
467 incomplete read/write - retrying/giving up
469 .in -2
480 .in -2
491 .in -2
502 .in -2
513 .in -2
524 .in -2
535 .in -2
546 .in -2
557 .in -2
568 .in -2
579 .in -2
590 .in -2
601 .in -2