Lines Matching refs:with

40 OpenSSH has only been tested with GNU make. It may work with other
53 To install OpenSSH with default options:
88 --with-rsh=PATH allows you to specify the path to your rsh program. 
100 --with-random=/some/file allows you to specify an alternate source of
104 --with-egd-pool=/some/file allows you to enable Entropy Gathering
109 --with-lastlog=FILE will specify the location of the lastlog file. 
115 --with-kerberos4=PATH will enable Kerberos IV support. You will need
120 --with-afs=PATH will enable AFS support. You will need to have the
125 --with-skey will enable S/Key one time password support. You will need
128 --with-tcp-wrappers will enable TCP Wrappers (/etc/hosts.allow|deny)
131 --with-md5-passwords will enable the use of MD5 passwords. Enable this
134 --with-utmpx enables utmpx support. utmpx support is automatic for 
139 --with-ipaddr-display forces the use of a numeric IP address in the 
142 --with-default-path=PATH allows you to specify a default $PATH for sessions
145 --with-pid-dir=PATH specifies the directory in which the ssh.pid file is
148 --with-xauth=PATH specifies the location of the xauth binary
150 --with-ipv4-default instructs OpenSSH to use IPv4 by default for new
156 --with-ssl-dir=DIR allows you to specify where your OpenSSL libraries
159 --with-4in6 Check for IPv4 in IPv6 mapped addresses and convert them to
183 Replacing /etc/ssh with the correct path to the configuration directory.
184 (${prefix}/etc or whatever you specified with --sysconfdir during 
187 If you have configured OpenSSH with EGD support, ensure that EGD is