Lines Matching +full:application +full:- +full:dependent

34 .Bl -bullet -offset indent
47 During the Identification phase, the application retrieves a set of device
57 During the Setup phase the application sets some interface attributes and
88 may set non-zero error code as appropriate.
101 The application can perform some additional cleanup
106 .Bl -tag -width PRNIOC_GET_IFINFO
108 Application can retrieve printer interface capabilities using this command.
117 .Bl -tag -width PRN_1284_STATUS
120 bidirectional mode, instead of forward-only mode.
122 If this bit is set, the interface allows device hot-plugging.
152 This bit impacts the application abort phase behaviour.
155 capability, the application must issue an
175 .Bl -tag -width PRN_BIDI
178 bidirectional mode, instead of forward-only mode.
195 .Bd -literal -offset 2n
203 The application allocates a buffer and sets
220 The application may then repeat the command with a bigger buffer.
229 .Bl -tag -width PRN_PARALLEL -compact
235 EIA-232/EIA-485 serial ports
251 device-specific, and in general, applications using this command should be
257 performed actions are completely driver-dependent.
264 .Em IEEE 1284-1994 .
270 .Bd -literal -offset 2n
278 For convenience, the two-byte length field is not considered part of device ID
282 value shall be set to (length - 2) by the driver, where length is the ID
290 The printer driver must return the most up-to-date value of the device ID.
297 .Bl -tag -width PRN_ONLINE
319 .Bl -tag -width PRN_1284_NOFAULT -compact
334 .Bd -literal -offset 2n
369 .%T IEEE Std 1284-1994