Lines Matching +full:reboot +full:- +full:mode
8 ata \- AT attachment disk driver
12 \fBide@unit-\fR\fIaddress\fR
26 A PCI IDE controller can operate in compatibility mode or in PCI-native mode.
28 compatibility mode.
32 the other to slave. If both a PATA disk drive and a PATA CD-ROM drive utilize
34 CD-ROM drive as the slave, although this is not mandatory.
37 Supported settings for the primary controller when in compatibility mode are:
52 Supported settings for the secondary controller when in compatibility mode are:
66 Note -
69 When in PCI-native mode, the IRQ and I/O address resources are configured by
78 controller. As a result, you should configure BIOS to select IDE mode rather
79 than RAID mode. Some systems may require updating BIOS to allow switching
93 Panasonic LK-MC579B and the Mitsumi FX34005 IDE CD-ROM drives are not supported
100 CMD-604 is unable to handle simultaneous I/O on both IDE interfaces. This
108 NEC CDR-260/CDR-260R/CDR-273 and Sony CDU-55E ATAPI CD-ROM drives might fail
115 Sony CDU-701 CD-ROM drives must be upgraded to use firmware version 1.0r or
118 A Compact Flash(CF) card can work as an ATA disk through a CF-to-ATA adapter.
120 If either of them does not, you should set ata-disk-dma-enabled to '0.'
136 not effective until you reboot the system. Property modifications via the
142 atapi-cd-dma-enabled to 0 using the boot loader command line.
146 \fB\fBata-dma-enabled\fR\fR
158 \fB\fBata-disk-dma-enabled\fR\fR
162 ata-dma-enabled is not set to '0.'
164 If ata-disk-dma-enabled set to '0,' DMA is disabled for all ATA disks in the
174 \fB\fBatapi-cd-dma-enabled\fR\fR
178 ata-dma-enabled is not set to '0.'
180 If atapi-cd-dma-enabled is absent or set to '0,' DMA is disabled for all ATAPI
192 \fB\fBatapi-other-dma-enabled\fR\fR
195 This property is examined only for non-CD/DVD ATAPI devices such as ATAPI tape
196 drives, and only if ata-dma-enabled is not set to '0.'
198 If atapi-other-dma-enabled is set to '0,' DMA is disabled for all non-CD/DVD
229 be unable to reboot the system. For x86 based systems, it is recommended that
238 \fB\fBata-revert-to-defaults\fR\fR
246 drive to return to the power-on settings when the drive receives a software
249 to 1 may prevent some systems from soft-rebooting and would require cycling the
254 may have to press the reset button or power-cycle) and then view
258 "_", and "-". Change uppercase letters to lower case. If the string
259 revert-<diskmodel> is longer than 31 characters, use only the first 31
269 \fB# for higher performance - set block factor to 16
281 \fBrevert-st320420a=1;\fR
317 Enter: boot -B atapi-cd-dma-enabled=1
329 eeprom 'atapi-cd-dma-enabled=1'
385 \fIINCITS T13 ATA/ATAPI-7\fR specifications