Lines Matching refs:the
4 # The contents of this file are subject to the terms of the
5 # Common Development and Distribution License (the "License").
6 # You may not use this file except in compliance with the License.
8 # You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE
10 # See the License for the specific language governing permissions
11 # and limitations under the License.
14 # file and include the License file at usr/src/OPENSOLARIS.LICENSE.
15 # If applicable, add the following below this CDDL HEADER, with the
34 # the interface name to the parameter name. For example, to make
48 # By default, when the DHCP agent is sent a SIGTERM (typically when
49 # the system is shut down), all managed addresses are dropped rather
50 # than released. Dropping an address does not notify the DHCP server
51 # that the address is no longer in use, leaving it possibly available
52 # for subsequent use by the same client. If DHCP is later restarted
53 # on the interface, the client will ask the server if it can continue
54 # to use the address. If the server either grants the request, or
55 # does not answer (and the lease has not yet expired), then the client
56 # will use the original address.
58 # Similarly, when the system is suspended and then woken up or when
59 # the link status transitions from down to up, DHCP will ask the server
60 # to continue to use the managed address, in case the lease has changed.
62 # By uncommenting the following parameter-value pairs, all managed
65 # received, the DHCP server is notified that the address is available
66 # for use, and the address will not be saved for a later restart. If
68 # the previous lease, but if unable to do so, it will not attempt to
74 # By default, the DHCP agent waits 3 seconds to collect OFFER
77 # behavior, set and uncomment the following parameter-value pair.
78 # Note: this does not control the retransmission strategy for
84 # By default, the DHCP agent does not send out a client identifier
85 # (and hence, the chaddr field is used by the DHCP server as the
86 # client identifier.) To make the DHCP agent send a client
87 # identifier, set and uncomment the following parameter-value pair.
90 # digits (for example, the value 0xAABBCC11 would set the client
91 # identifier to the 4-byte binary sequence 0xAA 0xBB 0xCC 0x11).
97 # that is not a logical interface, the DHCP agent will forgo sending a
103 # uncomment the following line.
107 # By default, the DHCP agent will try to request the Fully Qualified Domain
108 # Name (FQDN) currently associated with the interface performing DHCP. The
109 # hostname is defined by using the -h,--reqhost option of ipadm(8) or the
110 # ncu ip-reqhost property of nwamcfg(8) or by flagging the interface as
111 # primary so that nodename(5) is used as the hostname.
113 # A defined hostname will be used as the FQDN if it is "rooted" (i.e., if
115 # srv.example.com). If the hostname is not an FQDN, then DNS_DOMAINNAME
117 # if active. If no FQDN can be determined, the option will not be used.
120 # to the DHCP server along with RFC 4702 options to request that a
122 # records. To prevent sending FQDN and DNS options, uncomment the line
126 # 4702 (3.1): "clients that send the Client FQDN option in their messages
127 # MUST NOT also send the Host Name."
131 # By default, the DHCP agent will not attempt to construct an FQDN from a
132 # PQDN specified by the -h,--reqhost option of ipadm(8), by the ncu
134 # uncomment the following parameter to indicate a domain name to be used by
135 # the DHCP agent to construct if necessary an FQDN.
139 # By default, the DHCP agent will not attempt to use a domain name returned
140 # by the DHCP server or the domain in resolv.conf(5) to construct an FQDN
141 # from a PQDN specified by the -h,--reqhost option of ipadm(8), by the ncu
143 # the following parameter to indicate that a returned DHCPv4 DNSdmain or the
144 # domain from resolv.conf(5) should be adopted by the DHCP agent to
149 # By default, the DHCP agent will try to request the hostname currently
150 # associated with the interface performing DHCP. If this option is
151 # enabled, the agent will attempt to use an -h,--reqhost option saved with
154 # line of the form
160 # these configurations, the token will be used to request that host name
161 # from the DHCP server. To prevent this, uncomment the following line.
165 # By default, the DHCP agent will set the MTU of the link if the MTU option
166 # (26) is provided by the server. To prevent this, uncomment the following
173 # address (28), and encapsulated vendor options (43), is sent to the DHCP
174 # server when the DHCP agent sends requests. However, if desired, this can be
175 # changed by altering the following parameter-value pair. The numbers
176 # correspond to the values defined in the IANA bootp-dhcp-parameters registry
177 # at the time of this writing. Site and standard option names from
184 # NIS domain (29). This may be changed by altering the following parameter-
185 # value pair. The numbers correspond to the values defined in the IANA
186 # dhcpv6-parameters registry at the time of this writing. Site and standard
190 # The parameter ignore list allows you to instruct the DHCP client to discard
191 # optional parameters received from the DHCP server. The format is the same
192 # as the request list above. When discarded, a parameter will not be acted
193 # on by the DHCP client or returned to users via the dhcpinfo(1) command.