Lines Matching +full:system +full:- +full:cache +full:- +full:controller

153 .Cm cache Ar volume Op Ar setting Oo Ar value Oc Op ...
270 .Bl -tag -width indent
273 specifies the device node of the controller to use.
280 specifies the type of the controller to work with either
288 specifies the unit of the controller to work with.
294 .Bl -tag -width indent
339 The first group of commands provide information about the controller,
342 attached to the controller.
344 managed by the controller.
346 the controller.
347 The fifth group of commands are used to manage controller-wide operations.
350 .Bl -tag -width indent
355 Displays information about the RAID controller such as the model number.
359 Displays the volume and drive configuration for the controller.
364 Lists all of the physical drives attached to the controller.
372 Display entries from the controller's event log.
373 The controller maintains a circular buffer of events.
382 .Bl -tag -width indent
386 Periodic progress updates for long-running operations such as background
398 The controller itself has died.
403 parameter limits the output to entries for the specified part of the controller.
412 .Dq controller ,
421 the controller for each low-level request.
433 .Bl -tag -width indent
441 The entry in the event log corresponding to the last time the controller was
447 Lists all of the firmware images present on the controller.
453 Display the status of the controller's patrol read operation.
458 Lists all of the logical volumes managed by the controller.
462 .Bl -tag -width indent
482 Present the drive to the host operating system as a disk SYSPD block device in
496 Abort an in-progress rebuild operation on
507 .Bl -tag -width indent
508 .It Cm cache Ar volume Op Ar setting Oo Ar value Oc Op ...
511 arguments are supplied, then the current cache policy for
515 the cache policy for
525 .Bl -tag -width indent
534 .It Cm write-back
535 Use write-back policy for cached writes.
536 .It Cm write-through
537 Use write-through policy for cached writes.
538 .It Cm read-ahead Ar value
547 .It Cm bad-bbu-write-cache Ar value
557 the system loses power.
558 .It Cm write-cache Ar value
571 The battery backup of the RAID controller does not save data in the write
585 .Bl -tag -width indent
599 .Bl -tag -width indent
658 will be used as a global hot spare backing all arrays for this controller.
670 The controller management commands include:
671 .Bl -tag -width indent
677 .Bl -tag -width indent
692 argument specifies a non-negative, relative start time for the next patrol read.
733 Updates the flash on the controller with the firmware stored in
740 In particular, the controller write cache will be disabled during the relearn
745 .Bl -tag -width indent
746 .It Cm learn-delay
749 .It Cm autolearn-mode
760 .It Cm bbu-mode
770 With an integer argument (0-100), set that value as the new rebuild rate for volumes.
777 Configure the cache for volume mfid0 to cache only writes:
779 .Dl Nm Cm cache mfid0 writes
780 .Dl Nm Cm cache mfid0 write-back
786 Configure the first three disks on a controller as JBOD: