Lines Matching full:drive

47 utility is used to command a magnetic tape drive for operations
76 This returns as soon as the command has been validated by the tape drive.
121 With drive data compression especially,
123 sent to the drive than the amount of data written to tape.
133 Rewind the tape and place the drive off line.
136 Load the tape into the drive.
145 Output status information about the drive.
155 hardware or SCSI logical block position (if the drive supports such) are
177 Report the block limits of the tape drive, including the minimum and
197 Set the block size for the drive.
201 except 0 commands the drive to use variable-length blocks.
214 Output status information about the drive.
223 If the tape drive supports the long form report of the
228 The BOP flag means that the logical position of the drive is at the
231 The EOP flag means that the logical position of the drive is between Early
234 The BPEW flag means that the logical position of the drive is in a
254 Report density support information for the tape drive and any media that is
262 tapes they support and the tape currently in the drive.
314 Display or set drive protection parameters.
351 When set, this indicates that each block read from the tape drive will
358 When set, this indicates that each block written to the tape drive will have
360 The drive will verify the checksum before writing the block to tape.
363 Set the tape drive's logical position.
371 If the partition number is specified, the drive will first relocate to the
374 If the partition number is not specified, the drive will relocate to the
391 Set the drive's compression mode.
414 supply a numeric compression algorithm for the drive to use.
419 supported by the drive.
424 supply a numeric compression value from the drive's specifications.
428 drive to record data in its compressed format.
430 is selected, the drive will return an error.
433 Set the density for the drive.
564     not listed in the manual.  Someone with access to a drive can
573     drive.  It cannot be read by an LTO-7 drive.  Uncompressed capacity
628 if the tape drive has dust covering the light sensor that looks for the end
633 This is the pathname of the tape drive.
646 The exit status will be 0 when the drive operations were successful,
647 2 when the drive operations were unsuccessful, and 1 for other
648 problems like an unrecognized command or a missing drive device.
689 when the drive uses internal compression.