Lines Matching +full:800 +full:mbps

1060 …alue of the non-deemphasized voltage level at the transmitter pins: 0x0 =  800-1200 mV for full sw…
5743 …            (0x1<<11) // This bit is used to disable function 1. Bit 17 of 800 can also be used. T…
38003 …800MHz 10 for VCO lt 800MHz [25:24] post_resetb select post channel resetb selection 00 = lock or …
38006 …800MHz 10 for VCO lt 800MHz [25:24] post_resetb select post channel resetb selection 00 = lock or …
38036 …800MHz 10 for VCO lt 800MHz [25:24] post_resetb select post channel resetb selection 00 = lock or …
38038 …800MHz 10 for VCO lt 800MHz [25:24] post_resetb select post channel resetb selection 00 = lock or …
39605 …sed to set the core mode of operation: 000: Enable 10Mbps  Ethernet mode (SGMII) 001: Enable 100Mb…
39619 …'0'; used to set the core mode of operation: 00: Enable 10Mbps Ethernet mode 01: Enable 100Mbps Et…
39681 …                            (0x3<<0) // MAC Speed. 00: 10Mbps Ethernet Mode enabled 01: 100Mbps Et…
39718 …ished at 10Mbps; LPI is not supported (saving is achieved by reduced PHY's output swing). UNIMAC i…
39722 …s to LPI State. The decrement unit is 1 micro-second. This register is meant for 10/100 Mbps speed.
39723 …ons to LPI State. The decrement unit is 1 micro-second. This register is meant for 1000 Mbps speed.
39727 …r transmission. The decrement unit is 1 micro-second. This register is meant for 10/100 Mbps speed.
39728 …for transmission. The decrement unit is 1 micro-second. This register is meant for 1000 Mbps speed.
74327 …REG_CMSG_QUE_SIZE_E5                                                                            800