Lines Matching +full:antenna +full:- +full:sku
1 /*-
2 * SPDX-License-Identifier: BSD-2-Clause
4 * Copyright (c) 2007-2009 Sam Leffler, Errno Consulting
5 * Copyright (c) 2007-2009 Marvell Semiconductor, Inc.
39 #define MWL_MBSS_SUPPORT /* enable multi-bss support */
85 * Query whether multi-bss support is available/enabled.
132 cause = bus_space_read_4(mh->mh_iot, mh->mh_ioh, in mwl_hal_getisr()
138 bus_space_write_4(mh->mh_iot, mh->mh_ioh, in mwl_hal_getisr()
139 MACREG_REG_A2H_INTERRUPT_CAUSE, cause &~ mh->mh_imask); in mwl_hal_getisr()
140 (void) bus_space_read_4(mh->mh_iot, mh->mh_ioh, in mwl_hal_getisr()
142 cause &= mh->mh_imask; in mwl_hal_getisr()
163 bus_space_write_4(mh->mh_iot, mh->mh_ioh, in mwl_hal_txstart()
165 (void) bus_space_read_4(mh->mh_iot, mh->mh_ioh, MACREG_REG_INT_CODE); in mwl_hal_txstart()
204 uint16_t numAntennas; /* Number of antenna used */
210 uint32_t wcbBase[MWL_NUM_TX_QUEUES - MWL_NUM_ACK_QUEUES];
215 * Supply tx/rx dma-related settings to the firmware.
222 uint32_t wcbBase[MWL_NUM_TX_QUEUES - MWL_NUM_ACK_QUEUES];
259 uint32_t RxNonCtlPkts; /* rx non-control frames */
290 * Set Antenna Configuration (legacy operation).
292 * The RX antenna can be selected using the bitmask
293 * ant (bit 0 = antenna 1, bit 1 = antenna 2, etc.)
328 * Initiate an 802.11h-based channel switch. The CSA ie
339 * Set regdomain code (IEEE SKU).
356 * interpreted as MCS codes (this limits us to 0-127). The
416 #define KEY_TYPE_ID_AES 2 /* AES-CCMP */
497 * A-MPDU Block Ack (BA) stream support. There are several
524 * Set/get A-MPDU aggregation parameters.
589 * If set is non-zero the AID is enabled, if zero it is removed.
666 * Enable/disable CF-End use.
671 * Enable/disable sta-mode DWDS use/operation.
676 * Diagnostic interface. This is an open-ended interface that