Lines Matching +full:0 +full:x0100

36 #define	MII_ACPHY_POL		0x10	/* Polarity int level */
39 #define	MII_ACPHY_INT		0x11	/* Interrupt control/status */
40 #define	AC_INT_ACOMP		0x0001	/* Autoneg complete */
41 #define	AC_INT_REM_FLT		0x0002	/* Remote fault */
42 #define	AC_INT_LINK_DOWN	0x0004	/* Link not OK */
43 #define	AC_INT_LP_ACK		0x0008	/* FLP ack recved */
44 #define	AC_INT_PD_FLT		0x0010	/* Parallel detect fault */
45 #define	AC_INT_PAGE_RECV	0x0020	/* New page recved */
46 #define	AC_INT_RX_ER		0x0040	/* RX_ER transitions high */
47 #define	AC_INT_JAB		0x0080	/* Jabber detected */
49 #define	MII_ACPHY_DIAG		0x12	/* Diagnostic */
50 #define	AC_DIAG_RX_LOCK		0x0100
51 #define	AC_DIAG_RX_PASS		0x0200
52 #define	AC_DIAG_SPEED		0x0400	/* Aneg speed result */
53 #define	AC_DIAG_DUPLEX		0x0800	/* Aneg duplex result */
55 #define	MII_ACPHY_PWRLOOP	0x13	/* Power/Loopback */
56 #define	MII_ACPHY_CBLMEAS	0x14	/* Cable meas. */
58 #define	MII_ACPHY_MCTL		0x15	/* Mode control */
59 #define	AC_MCTL_FX_SEL		0x0001	/* FX mode */
60 #define	AC_MCTL_BYP_PCS		0x0002	/* Bypass PCS */
61 #define	AC_MCTL_SCRMBL		0x0004	/* Data scrambling */
62 #define	AC_MCTL_REM_LOOP	0x0008	/* Remote loopback */
63 #define	AC_MCTL_DIS_WDT		0x0010	/* Disable watchdog timer */
64 #define	AC_MCTL_DIS_REC		0x0020	/* Disable recv error counter */
65 #define	AC_MCTL_REC_FULL	0x0040	/* Recv error counter full */
66 #define	AC_MCTL_FRC_FEF		0x0080	/* Force Far End Fault Insert. */
67 #define	AC_MCTL_DIS_FEF		0x0100	/* Disable FEF Insertion */
68 #define	AC_MCTL_LED_SEL		0x0200	/* Compat LED config */
69 #define	AC_MCTL_ALED_SEL	0x0400	/* ActLED RX&TX - RX only */
70 #define	AC_MCTL_10BT_SEL	0x0800	/* Enable 7-wire interface */
71 #define	AC_MCTL_DIS_JAB		0x1000	/* Disable jabber */
72 #define	AC_MCTL_FRC_LINK	0x2000	/* Force TX link up */
73 #define	AC_MCTL_DIS_NLP		0x4000	/* Disable NLP check */
75 #define	MII_ACPHY_REC		0x18	/* Recv error counter */