Lines Matching +defs:build +defs:mode

252  *         Indicates current power-saving mode:
269  *         Host sets this to put device into fully operational D0 power mode.
270  *         Host resets this after SW_RESET to put device into low power mode.
278  *                SRAM is restored and uCode is in normal operation mode.
373  *         unassociated mode, and power down.
897  * @IWM_UCODE_TLV_CAPA_UMAC_UPLOAD: supports upload mode in umac (1=supported,
916  * @IWM_UCODE_TLV_CAPA_LMAC_UPLOAD: supports upload mode in lmac (1=supported,
1072 			uint32_t build;		/* build number */
1179 	uint32_t build;
1295  *     block-ack (BA) window of up to 64 TFDs.  In this mode, each queue
1300  *     In scheduler-ack mode, the scheduler keeps track of the Tx status of
1308  *     for this mode.
1309  *     This mode does not support fragmentation.
1316  *     The command queue (#4/#9) must use this mode!
1317  *     This mode does not require use of the Byte Count table in host DRAM.
1454  * from going into a power-savings mode that would cause higher DRAM latency,
1935  * Although the queues in DQA mode are dynamically allocated, there are still
4001  *	(in station mode when associated)
4855  * @IWM_PM_FRAME_NONE: no need to suspend sleep mode
4856  * @IWM_PM_FRAME_MGMT: fw suspend sleep mode for 100TU
4857  * @IWM_PM_FRAME_ASSOC: fw suspend sleep mode for 10sec
6233  *	station info array (1 - n 1X mode)
6477  * @IWM_STA_GENERAL_PURPOSE: General purpose. In AP mode used for beacons
6615  * @mode: enum %iwm_bt_coex_mode
6621 	uint32_t mode;