Lines Matching +full:sco +full:- +full:routing
1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 #include <dt-bindings/usb/pd.h>
11 stdout-path = &uart2;
14 gpio-leds {
15 compatible = "gpio-leds";
16 pinctrl-names = "default";
17 pinctrl-0 = <&pinctrl_gpio_led>;
22 default-state = "on";
26 hdmi-connector {
27 compatible = "hdmi-connector";
33 remote-endpoint = <&adv7533_out>;
43 reg_usdhc2_vmmc: regulator-usdhc2 {
44 compatible = "regulator-fixed";
45 pinctrl-names = "default";
46 pinctrl-0 = <&pinctrl_reg_usdhc2_vmmc>;
47 regulator-name = "VSD_3V3";
48 regulator-min-microvolt = <3300000>;
49 regulator-max-microvolt = <3300000>;
51 off-on-delay-us = <12000>;
52 enable-active-high;
55 ir-receiver {
56 compatible = "gpio-ir-receiver";
58 pinctrl-names = "default";
59 pinctrl-0 = <&pinctrl_ir>;
60 linux,autosuspend-period = <125>;
63 audio_codec_bt_sco: audio-codec-bt-sco {
64 compatible = "linux,bt-sco";
65 #sound-dai-cells = <1>;
68 wm8524: audio-codec {
69 #sound-dai-cells = <0>;
71 pinctrl-names = "default";
72 pinctrl-0 = <&pinctrl_gpio_wlf>;
73 wlf,mute-gpios = <&gpio5 21 GPIO_ACTIVE_LOW>;
76 sound-bt-sco {
77 compatible = "simple-audio-card";
78 simple-audio-card,name = "bt-sco-audio";
79 simple-audio-card,format = "dsp_a";
80 simple-audio-card,bitclock-inversion;
81 simple-audio-card,frame-master = <&btcpu>;
82 simple-audio-card,bitclock-master = <&btcpu>;
84 btcpu: simple-audio-card,cpu {
85 sound-dai = <&sai2>;
86 dai-tdm-slot-num = <2>;
87 dai-tdm-slot-width = <16>;
90 simple-audio-card,codec {
91 sound-dai = <&audio_codec_bt_sco 1>;
95 sound-wm8524 {
96 compatible = "fsl,imx-audio-wm8524";
97 model = "wm8524-audio";
98 audio-cpu = <&sai3>;
99 audio-codec = <&wm8524>;
100 audio-asrc = <&easrc>;
101 audio-routing =
106 sound-spdif {
107 compatible = "fsl,imx-audio-spdif";
108 model = "imx-spdif";
109 spdif-controller = <&spdif1>;
110 spdif-out;
111 spdif-in;
116 fsl,asrc-rate = <48000>;
121 pinctrl-names = "default";
122 pinctrl-0 = <&pinctrl_fec1>;
123 phy-mode = "rgmii-id";
124 phy-handle = <ðphy0>;
125 fsl,magic-packet;
129 #address-cells = <1>;
130 #size-cells = <0>;
132 ethphy0: ethernet-phy@0 {
133 compatible = "ethernet-phy-ieee802.3-c22";
135 reset-gpios = <&gpio4 22 GPIO_ACTIVE_LOW>;
136 reset-assert-us = <10000>;
137 qca,disable-smarteee;
138 vddio-supply = <&vddio>;
140 vddio: vddio-regulator {
141 regulator-min-microvolt = <1800000>;
142 regulator-max-microvolt = <1800000>;
149 pinctrl-names = "default";
150 pinctrl-0 = <&pinctrl_flexspi>;
154 compatible = "jedec,spi-nor";
156 #address-cells = <1>;
157 #size-cells = <1>;
158 spi-max-frequency = <166000000>;
159 spi-tx-bus-width = <4>;
160 spi-rx-bus-width = <4>;
165 clock-frequency = <400000>;
166 pinctrl-names = "default";
167 pinctrl-0 = <&pinctrl_i2c1>;
172 clock-frequency = <400000>;
173 pinctrl-names = "default", "gpio";
174 pinctrl-0 = <&pinctrl_i2c2>;
175 pinctrl-1 = <&pinctrl_i2c2_gpio>;
176 scl-gpios = <&gpio5 16 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
177 sda-gpios = <&gpio5 17 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
183 reg-names = "main", "cec", "edid", "packet";
184 adi,dsi-lanes = <4>;
186 adi,input-depth = <8>;
187 adi,input-colorspace = "rgb";
188 adi,input-clock = "1x";
189 adi,input-style = <1>;
190 adi,input-justification = "evenly";
193 #address-cells = <1>;
194 #size-cells = <0>;
200 remote-endpoint = <&dsi_out>;
208 remote-endpoint = <&hdmi_connector_in>;
217 pinctrl-names = "default";
218 pinctrl-0 = <&pinctrl_typec1>;
220 interrupt-parent = <&gpio2>;
225 compatible = "usb-c-connector";
226 label = "USB-C";
227 power-role = "dual";
228 data-role = "dual";
229 try-power-role = "sink";
230 source-pdos = <PDO_FIXED(5000, 3000, PDO_FIXED_USB_COMM)>;
231 sink-pdos = <PDO_FIXED(5000, 3000, PDO_FIXED_USB_COMM)
233 op-sink-microwatt = <15000000>;
234 self-powered;
238 remote-endpoint = <&usb1_drd_sw>;
246 clock-frequency = <400000>;
247 pinctrl-names = "default", "gpio";
248 pinctrl-0 = <&pinctrl_i2c3>;
249 pinctrl-1 = <&pinctrl_i2c3_gpio>;
250 scl-gpios = <&gpio5 18 GPIO_ACTIVE_HIGH>;
251 sda-gpios = <&gpio5 19 GPIO_ACTIVE_HIGH>;
257 gpio-controller;
258 #gpio-cells = <2>;
264 pinctrl-names = "default";
265 pinctrl-0 = <&pinctrl_camera>;
267 clock-names = "xclk";
268 assigned-clocks = <&clk IMX8MN_CLK_CLKO1>;
269 assigned-clock-parents = <&clk IMX8MN_CLK_24M>;
270 assigned-clock-rates = <24000000>;
271 powerdown-gpios = <&gpio1 7 GPIO_ACTIVE_HIGH>;
272 reset-gpios = <&gpio1 6 GPIO_ACTIVE_LOW>;
276 remote-endpoint = <&imx8mn_mipi_csi_in>;
277 clock-lanes = <0>;
278 data-lanes = <1 2>;
294 remote-endpoint = <&ov5640_to_mipi_csi2>;
295 data-lanes = <1 2>;
306 samsung,esc-clock-frequency = <10000000>;
314 remote-endpoint = <&adv7533_in>;
315 data-lanes = <1 2 3 4>;
322 #sound-dai-cells = <0>;
323 pinctrl-names = "default";
324 pinctrl-0 = <&pinctrl_sai2>;
325 assigned-clocks = <&clk IMX8MN_CLK_SAI2>;
326 assigned-clock-parents = <&clk IMX8MN_AUDIO_PLL1_OUT>;
327 assigned-clock-rates = <24576000>;
332 pinctrl-names = "default";
333 pinctrl-0 = <&pinctrl_sai3>;
334 assigned-clocks = <&clk IMX8MN_CLK_SAI3>;
335 assigned-clock-parents = <&clk IMX8MN_AUDIO_PLL1_OUT>;
336 assigned-clock-rates = <24576000>;
337 fsl,sai-mclk-direction-output;
346 pinctrl-names = "default";
347 pinctrl-0 = <&pinctrl_spdif1>;
348 assigned-clocks = <&clk IMX8MN_CLK_SPDIF1>;
349 assigned-clock-parents = <&clk IMX8MN_AUDIO_PLL1_OUT>;
350 assigned-clock-rates = <24576000>;
355 pinctrl-names = "default";
356 pinctrl-0 = <&pinctrl_uart1>;
357 assigned-clocks = <&clk IMX8MN_CLK_UART1>;
358 assigned-clock-parents = <&clk IMX8MN_SYS_PLL1_80M>;
359 uart-has-rtscts;
364 pinctrl-names = "default";
365 pinctrl-0 = <&pinctrl_uart2>;
370 pinctrl-names = "default";
371 pinctrl-0 = <&pinctrl_uart3>;
372 assigned-clocks = <&clk IMX8MN_CLK_UART3>;
373 assigned-clock-parents = <&clk IMX8MN_SYS_PLL1_80M>;
374 uart-has-rtscts;
379 wakeup-source;
384 hnp-disable;
385 srp-disable;
386 adp-disable;
387 usb-role-switch;
388 disable-over-current;
389 samsung,picophy-pre-emp-curr-control = <3>;
390 samsung,picophy-dc-vol-level-adjust = <7>;
395 remote-endpoint = <&typec1_dr_sw>;
401 assigned-clocks = <&clk IMX8MN_CLK_USDHC2>;
402 assigned-clock-rates = <200000000>;
403 pinctrl-names = "default", "state_100mhz", "state_200mhz";
404 pinctrl-0 = <&pinctrl_usdhc2>, <&pinctrl_usdhc2_gpio>;
405 pinctrl-1 = <&pinctrl_usdhc2_100mhz>, <&pinctrl_usdhc2_gpio>;
406 pinctrl-2 = <&pinctrl_usdhc2_200mhz>, <&pinctrl_usdhc2_gpio>;
407 cd-gpios = <&gpio1 15 GPIO_ACTIVE_LOW>;
408 bus-width = <4>;
409 vmmc-supply = <®_usdhc2_vmmc>;
414 assigned-clocks = <&clk IMX8MN_CLK_USDHC3_ROOT>;
415 assigned-clock-rates = <400000000>;
416 pinctrl-names = "default", "state_100mhz", "state_200mhz";
417 pinctrl-0 = <&pinctrl_usdhc3>;
418 pinctrl-1 = <&pinctrl_usdhc3_100mhz>;
419 pinctrl-2 = <&pinctrl_usdhc3_200mhz>;
420 bus-width = <8>;
421 non-removable;
426 pinctrl-names = "default";
427 pinctrl-0 = <&pinctrl_wdog>;
428 fsl,ext-reset-output;
611 pinctrl_usdhc2_100mhz: usdhc2-100mhzgrp {
623 pinctrl_usdhc2_200mhz: usdhc2-200mhzgrp {
651 pinctrl_usdhc3_100mhz: usdhc3-100mhzgrp {
667 pinctrl_usdhc3_200mhz: usdhc3-200mhzgrp {