Lines Matching +full:buck4 +full:- +full:supply
1 // SPDX-License-Identifier: GPL-2.0+ OR MIT
6 #include <dt-bindings/interrupt-controller/irq.h>
10 model = "Kontron OSM-S i.MX8MM (N802X SOM)";
11 compatible = "kontron,imx8mm-osm-s", "fsl,imx8mm";
29 stdout-path = &uart3;
34 cpu-supply = <®_vdd_arm>;
38 cpu-supply = <®_vdd_arm>;
42 cpu-supply = <®_vdd_arm>;
46 cpu-supply = <®_vdd_arm>;
50 operating-points-v2 = <&ddrc_opp_table>;
52 ddrc_opp_table: opp-table {
53 compatible = "operating-points-v2";
55 opp-100000000 {
56 opp-hz = /bits/ 64 <100000000>;
59 opp-750000000 {
60 opp-hz = /bits/ 64 <750000000>;
66 pinctrl-names = "default";
67 pinctrl-0 = <&pinctrl_ecspi1>;
68 cs-gpios = <&gpio5 9 GPIO_ACTIVE_LOW>;
72 compatible = "mxicy,mx25r1635f", "jedec,spi-nor";
73 spi-max-frequency = <80000000>;
77 compatible = "fixed-partitions";
78 #address-cells = <1>;
79 #size-cells = <1>;
82 label = "u-boot";
100 clock-frequency = <400000>;
101 pinctrl-names = "default";
102 pinctrl-0 = <&pinctrl_i2c1>;
108 pinctrl-names = "default";
109 pinctrl-0 = <&pinctrl_pmic>;
110 interrupt-parent = <&gpio1>;
115 regulator-name = "+0V8_VDD_SOC (BUCK1)";
116 regulator-min-microvolt = <800000>;
117 regulator-max-microvolt = <850000>;
118 regulator-boot-on;
119 regulator-always-on;
120 regulator-ramp-delay = <3125>;
121 nxp,dvs-run-voltage = <850000>;
122 nxp,dvs-standby-voltage = <800000>;
126 regulator-name = "+0V9_VDD_ARM (BUCK2)";
127 regulator-min-microvolt = <850000>;
128 regulator-max-microvolt = <950000>;
129 regulator-boot-on;
130 regulator-always-on;
131 regulator-ramp-delay = <3125>;
132 nxp,dvs-run-voltage = <950000>;
133 nxp,dvs-standby-voltage = <850000>;
137 regulator-name = "+0V9_VDD_DRAM&PU (BUCK3)";
138 regulator-min-microvolt = <850000>;
139 regulator-max-microvolt = <950000>;
140 regulator-boot-on;
141 regulator-always-on;
144 reg_vdd_3v3: BUCK4 {
145 regulator-name = "+3V3 (BUCK4)";
146 regulator-min-microvolt = <3300000>;
147 regulator-max-microvolt = <3300000>;
148 regulator-boot-on;
149 regulator-always-on;
153 regulator-name = "+1V8 (BUCK5)";
154 regulator-min-microvolt = <1800000>;
155 regulator-max-microvolt = <1800000>;
156 regulator-boot-on;
157 regulator-always-on;
161 regulator-name = "+1V1_NVCC_DRAM (BUCK6)";
162 regulator-min-microvolt = <1100000>;
163 regulator-max-microvolt = <1100000>;
164 regulator-boot-on;
165 regulator-always-on;
169 regulator-name = "+1V8_NVCC_SNVS (LDO1)";
170 regulator-min-microvolt = <1800000>;
171 regulator-max-microvolt = <1800000>;
172 regulator-boot-on;
173 regulator-always-on;
177 regulator-name = "+0V8_VDD_SNVS (LDO2)";
178 regulator-min-microvolt = <800000>;
179 regulator-max-microvolt = <900000>;
180 regulator-boot-on;
181 regulator-always-on;
185 regulator-name = "+1V8_VDDA (LDO3)";
186 regulator-min-microvolt = <1800000>;
187 regulator-max-microvolt = <1800000>;
188 regulator-boot-on;
189 regulator-always-on;
193 regulator-name = "+0V9_VDD_PHY (LDO4)";
194 regulator-min-microvolt = <900000>;
195 regulator-max-microvolt = <900000>;
196 regulator-boot-on;
197 regulator-always-on;
201 regulator-name = "NVCC_SD (LDO5)";
202 regulator-min-microvolt = <1800000>;
203 regulator-max-microvolt = <3300000>;
211 pinctrl-names = "default";
212 pinctrl-0 = <&pinctrl_rtc>;
213 interrupts-extended = <&gpio4 1 IRQ_TYPE_LEVEL_HIGH>;
214 trickle-diode-disable;
219 pinctrl-names = "default";
220 pinctrl-0 = <&pinctrl_uart3>;
225 pinctrl-names = "default", "state_100mhz", "state_200mhz";
226 pinctrl-0 = <&pinctrl_usdhc1>;
227 pinctrl-1 = <&pinctrl_usdhc1_100mhz>;
228 pinctrl-2 = <&pinctrl_usdhc1_200mhz>;
229 vmmc-supply = <®_vdd_3v3>;
230 vqmmc-supply = <®_vdd_1v8>;
231 bus-width = <8>;
232 non-removable;
237 pinctrl-names = "default";
238 pinctrl-0 = <&pinctrl_wdog>;
239 fsl,ext-reset-output;
296 pinctrl_usdhc1_100mhz: usdhc1-100mhzgrp {
313 pinctrl_usdhc1_200mhz: usdhc1-200mhzgrp {