Lines Matching +full:cpvdd +full:- +full:supply
1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
4 /dts-v1/;
6 #include "sun50i-a64.dtsi"
7 #include "sun50i-a64-cpu-opp.dtsi"
9 #include <dt-bindings/gpio/gpio.h>
13 compatible = "pine64,pine64", "allwinner,sun50i-a64";
25 stdout-path = "serial0:115200n8";
28 hdmi-connector {
29 compatible = "hdmi-connector";
34 remote-endpoint = <&hdmi_out_con>;
45 cpvdd-supply = <®_eldo1>;
50 cpu-supply = <®_dcdc2>;
54 cpu-supply = <®_dcdc2>;
58 cpu-supply = <®_dcdc2>;
62 cpu-supply = <®_dcdc2>;
82 pinctrl-names = "default";
83 pinctrl-0 = <&rmii_pins>;
84 phy-mode = "rmii";
85 phy-handle = <&ext_rmii_phy1>;
86 phy-supply = <®_dc1sw>;
92 hvcc-supply = <®_dldo1>;
98 remote-endpoint = <&hdmi_con_in>;
107 bias-pull-up;
111 ext_rmii_phy1: ethernet-phy@1 {
112 compatible = "ethernet-phy-ieee802.3-c22";
118 pinctrl-names = "default";
119 pinctrl-0 = <&mmc0_pins>;
120 vmmc-supply = <®_dcdc1>;
121 cd-gpios = <&pio 5 6 GPIO_ACTIVE_LOW>;
122 disable-wp;
123 bus-width = <4>;
139 compatible = "x-powers,axp803";
141 interrupt-parent = <&r_intc>;
157 regulator-always-on;
158 regulator-min-microvolt = <1800000>;
159 regulator-max-microvolt = <3300000>;
160 regulator-name = "vcc-pl";
164 regulator-always-on;
165 regulator-min-microvolt = <3000000>;
166 regulator-max-microvolt = <3000000>;
167 regulator-name = "vcc-pll-avcc";
171 regulator-name = "vcc-phy";
175 regulator-always-on;
176 regulator-min-microvolt = <3300000>;
177 regulator-max-microvolt = <3300000>;
178 regulator-name = "vcc-3v3";
182 regulator-always-on;
183 regulator-min-microvolt = <1040000>;
184 regulator-max-microvolt = <1300000>;
185 regulator-name = "vdd-cpux";
191 * The DRAM chips used by Pine64 boards are DDR3L-compatible, so they can
196 regulator-always-on;
197 regulator-min-microvolt = <1360000>;
198 regulator-max-microvolt = <1360000>;
199 regulator-name = "vcc-dram";
203 regulator-always-on;
204 regulator-min-microvolt = <1100000>;
205 regulator-max-microvolt = <1100000>;
206 regulator-name = "vdd-sys";
210 regulator-min-microvolt = <3300000>;
211 regulator-max-microvolt = <3300000>;
212 regulator-name = "vcc-hdmi";
216 regulator-min-microvolt = <3300000>;
217 regulator-max-microvolt = <3300000>;
218 regulator-name = "vcc-mipi";
222 regulator-min-microvolt = <3300000>;
223 regulator-max-microvolt = <3300000>;
224 regulator-name = "vcc-wifi";
228 regulator-min-microvolt = <1800000>;
229 regulator-max-microvolt = <1800000>;
230 regulator-name = "cpvdd";
234 regulator-min-microvolt = <1200000>;
235 regulator-max-microvolt = <1200000>;
236 regulator-name = "vcc-1v2-hsic";
245 regulator-always-on;
246 regulator-min-microvolt = <1100000>;
247 regulator-max-microvolt = <1100000>;
248 regulator-name = "vdd-cpus";
252 regulator-name = "vcc-rtc";
256 vcc-hdmi-supply = <®_dldo1>;
260 simple-audio-card,aux-devs = <&codec_analog>;
261 simple-audio-card,widgets = "Microphone", "Microphone Jack",
263 simple-audio-card,routing =
280 pinctrl-names = "default";
281 pinctrl-0 = <&uart0_pb_pins>;
287 pinctrl-names = "default";
288 pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
292 /* On Pi-2 connector */
294 pinctrl-names = "default";
295 pinctrl-0 = <&uart2_pins>;
301 pinctrl-names = "default";
302 pinctrl-0 = <&uart3_pins>;
308 pinctrl-names = "default";
309 pinctrl-0 = <&uart4_pins>;