Lines Matching +full:cpvdd +full:- +full:supply
1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
5 /dts-v1/;
7 #include "sun50i-a64.dtsi"
8 #include "sun50i-a64-cpu-opp.dtsi"
10 #include <dt-bindings/gpio/gpio.h>
13 model = "Amarula A64-Relic";
14 compatible = "amarula,a64-relic", "allwinner,sun50i-a64";
21 stdout-path = "serial0:115200n8";
25 compatible = "i2c-gpio";
26 sda-gpios = <&pio 4 13 GPIO_ACTIVE_HIGH>;
27 scl-gpios = <&pio 4 12 GPIO_ACTIVE_HIGH>;
28 i2c-gpio,delay-us = <5>;
29 #address-cells = <1>;
30 #size-cells = <0>;
35 pinctrl-names = "default";
36 pinctrl-0 = <&csi_mclk_pin>;
38 clock-names = "xclk";
40 AVDD-supply = <®_aldo1>;
41 DOVDD-supply = <®_dldo3>;
42 DVDD-supply = <®_eldo3>;
43 reset-gpios = <&pio 4 14 GPIO_ACTIVE_LOW>; /* CSI-RST-R: PE14 */
44 powerdown-gpios = <&pio 4 15 GPIO_ACTIVE_HIGH>; /* CSI-STBY-R: PE15 */
48 remote-endpoint = <&csi_ep>;
49 bus-width = <8>;
50 hsync-active = <1>; /* Active high */
51 vsync-active = <0>; /* Active low */
52 data-active = <1>; /* Active high */
53 pclk-sample = <1>; /* Rising */
59 wifi_pwrseq: wifi-pwrseq {
60 compatible = "mmc-pwrseq-simple";
62 clock-names = "ext_clock";
63 reset-gpios = <&r_pio 0 2 GPIO_ACTIVE_LOW>; /* WL-PMU-EN: PL2 */
68 cpu-supply = <®_dcdc2>;
72 cpu-supply = <®_dcdc2>;
76 cpu-supply = <®_dcdc2>;
80 cpu-supply = <®_dcdc2>;
88 remote-endpoint = <&ov5640_ep>;
89 bus-width = <8>;
90 hsync-active = <1>; /* Active high */
91 vsync-active = <0>; /* Active low */
92 data-active = <1>; /* Active high */
93 pclk-sample = <1>; /* Rising */
112 bias-pull-up;
121 AVDD28-supply = <®_ldo_io0>; /* VCC-CTP: GPIO0-LDO */
122 interrupt-parent = <&pio>;
124 irq-gpios = <&pio 7 4 GPIO_ACTIVE_HIGH>; /* CTP-INT: PH4 */
125 reset-gpios = <&pio 7 8 GPIO_ACTIVE_HIGH>; /* CTP-RST: PH8 */
126 touchscreen-inverted-x;
127 touchscreen-inverted-y;
132 pinctrl-names = "default";
133 pinctrl-0 = <&mmc1_pins>;
134 vmmc-supply = <®_dcdc1>;
136 * Schematic shows both dldo4 and eldo1 connected for vcc-io-wifi, but
138 * 0Ohm register to vcc-io-wifi so eldo1 is used.
140 vqmmc-supply = <®_eldo1>;
141 mmc-pwrseq = <&wifi_pwrseq>;
142 bus-width = <4>;
143 non-removable;
148 compatible = "brcm,bcm4329-fmac";
149 interrupt-parent = <&r_pio>;
150 interrupts = <0 3 IRQ_TYPE_LEVEL_LOW>; /* WL-WAKE-AP: PL3 */
151 interrupt-names = "host-wake";
156 pinctrl-names = "default";
157 pinctrl-0 = <&mmc2_pins>;
158 vmmc-supply = <®_dcdc1>;
159 bus-width = <8>;
160 non-removable;
161 cap-mmc-hw-reset;
173 compatible = "x-powers,axp803";
175 interrupt-parent = <&r_intc>;
177 x-powers,drive-vbus-en; /* set N_VBUSEN as output pin */
184 regulator-always-on;
185 regulator-min-microvolt = <2800000>;
186 regulator-max-microvolt = <2800000>;
187 regulator-name = "avdd-csi";
191 regulator-always-on;
192 regulator-min-microvolt = <1800000>;
193 regulator-max-microvolt = <3300000>;
194 regulator-name = "vcc-pl";
198 regulator-always-on;
199 regulator-min-microvolt = <3000000>;
200 regulator-max-microvolt = <3000000>;
201 regulator-name = "vcc-pll-avcc";
205 regulator-always-on;
206 regulator-min-microvolt = <3300000>;
207 regulator-max-microvolt = <3300000>;
208 regulator-name = "vcc-3v3";
212 regulator-always-on;
213 regulator-min-microvolt = <1040000>;
214 regulator-max-microvolt = <1300000>;
215 regulator-name = "vdd-cpux";
221 regulator-always-on;
222 regulator-min-microvolt = <1500000>;
223 regulator-max-microvolt = <1500000>;
224 regulator-name = "vcc-dram";
228 regulator-always-on;
229 regulator-min-microvolt = <1100000>;
230 regulator-max-microvolt = <1100000>;
231 regulator-name = "vdd-sys";
235 regulator-min-microvolt = <3300000>;
236 regulator-max-microvolt = <3300000>;
237 regulator-name = "vcc-hdmi-dsi-sensor";
241 regulator-min-microvolt = <3300000>;
242 regulator-max-microvolt = <3300000>;
243 regulator-name = "vcc-mipi";
247 regulator-min-microvolt = <2800000>;
248 regulator-max-microvolt = <2800000>;
249 regulator-name = "dovdd-csi";
253 regulator-min-microvolt = <3300000>;
254 regulator-max-microvolt = <3300000>;
255 regulator-name = "vcc-wifi-io";
259 regulator-name = "usb0-vbus";
264 regulator-always-on;
265 regulator-min-microvolt = <1800000>;
266 regulator-max-microvolt = <1800000>;
267 regulator-name = "cpvdd";
271 regulator-min-microvolt = <1800000>;
272 regulator-max-microvolt = <1800000>;
273 regulator-name = "dvdd-csi";
277 regulator-min-microvolt = <1200000>;
278 regulator-max-microvolt = <1200000>;
279 regulator-name = "vcc-1v2-hsic";
288 regulator-always-on;
289 regulator-min-microvolt = <1100000>;
290 regulator-max-microvolt = <1100000>;
291 regulator-name = "vdd-cpus";
295 regulator-min-microvolt = <2800000>;
296 regulator-max-microvolt = <2800000>;
297 regulator-name = "vcc-ctp";
302 regulator-name = "vcc-rtc";
306 pinctrl-names = "default";
307 pinctrl-0 = <&uart0_pb_pins>;
317 usb0_id_det-gpios = <&pio 7 9 GPIO_ACTIVE_HIGH>; /* PH9 */
318 usb0_vbus-supply = <®_drivevbus>;