Lines Matching +full:rx +full:- +full:input

1 // SPDX-License-Identifier: GPL-2.0+ OR BSD-3-Clause
6 #include <dt-bindings/input/input.h>
7 #include <dt-bindings/pwm/pwm.h>
17 		stdout-path = "serial0:115200n8";
32 	 * GPIO line, however the STM32 UART driver assumes RX happens
34 	 * line. Hence, the RX is always enabled here.
36 	rs485-rx-en-hog {
37 		gpio-hog;
39 		output-low;
40 		line-name = "rs485-rx-en";
45 	gpio-line-names = "", "", "", "",
46 			  "", "", "DHCOM-B", "",
47 			  "", "", "", "DRC02-Out1",
48 			  "DRC02-Out2", "", "", "";
52 	gpio-line-names = "DRC02-In1", "DHCOM-O", "DHCOM-H", "DHCOM-I",
53 			  "DHCOM-R", "DHCOM-M", "", "",
54 			  "DRC02-In2", "", "", "",
64 	usb-hub-hog {
65 		gpio-hog;
67 		output-high;
68 		line-name = "usb-hub-reset";
73 	pinctrl-names = "default";
74 	pinctrl-0 = <&i2c2_pins_a>;
75 	i2c-scl-rising-time-ns = <185>;
76 	i2c-scl-falling-time-ns = <20>;
79 	/delete-property/dmas;
80 	/delete-property/dma-names;
97 	pinctrl-names = "default";
98 	pinctrl-0 = <&i2c5_pins_a>;
99 	i2c-scl-rising-time-ns = <185>;
100 	i2c-scl-falling-time-ns = <20>;
103 	/delete-property/dmas;
104 	/delete-property/dma-names;
110 	 * are used for on-board microSD slot instead.
112 	/delete-property/broken-cd;
113 	cd-gpios = <&gpioi 10 GPIO_ACTIVE_HIGH>;
114 	disable-wp;
118 	pinctrl-names = "default";
119 	pinctrl-0 = <&spi1_pins_a>;
120 	cs-gpios = <&gpioz 3 0>;
122 	/delete-property/dmas;
123 	/delete-property/dma-names;
132 	pinctrl-names = "default";
133 	pinctrl-0 = <&usart3_pins_a>;
134 	/delete-property/dmas;
135 	/delete-property/dma-names;
145 	linux,rs485-enabled-at-boot-time;
146 	pinctrl-names = "default";
147 	pinctrl-0 = <&uart8_pins_a>;
148 	rts-gpios = <&gpioe 6 GPIO_ACTIVE_HIGH>;
149 	/delete-property/dmas;
150 	/delete-property/dma-names;
163 	phy-supply = <&vdd_usb>;
167 	phy-supply = <&vdd_usb>;