Lines Matching +full:codec +full:- +full:gpio6
1 // SPDX-License-Identifier: GPL-2.0
3 * Device Tree Source for the iWave-RZ/G1M/G1N Qseven carrier board
9 * SSI-SGTL5000
40 stdout-path = "serial0:115200n8";
44 compatible = "fixed-clock";
45 #clock-cells = <0>;
46 clock-frequency = <26000000>;
50 compatible = "pwm-backlight";
53 brightness-levels = <0 4 8 16 32 64 128 255>;
54 default-brightness-level = <7>;
55 enable-gpios = <&gpio5 14 GPIO_ACTIVE_HIGH>;
58 lvds-receiver {
59 compatible = "ti,ds90cf384a", "lvds-decoder";
60 power-supply = <&vcc_3v3_tft1>;
63 #address-cells = <1>;
64 #size-cells = <0>;
69 remote-endpoint = <&lvds0_out>;
75 remote-endpoint = <&panel_in>;
84 power-supply = <&vcc_3v3_tft1>;
88 remote-endpoint = <&lvds_receiver_out>;
94 compatible = "regulator-fixed";
95 regulator-name = "1P5V";
96 regulator-min-microvolt = <1500000>;
97 regulator-max-microvolt = <1500000>;
98 regulator-always-on;
102 compatible = "simple-audio-card";
104 simple-audio-card,format = "i2s";
105 simple-audio-card,bitclock-master = <&sndcodec>;
106 simple-audio-card,frame-master = <&sndcodec>;
108 sndcpu: simple-audio-card,cpu {
109 sound-dai = <&rcar_sound>;
112 sndcodec: simple-audio-card,codec {
113 sound-dai = <&sgtl5000>;
117 vcc_3v3_tft1: regulator-panel {
118 compatible = "regulator-fixed";
120 regulator-name = "vcc-3v3-tft1";
121 regulator-min-microvolt = <3300000>;
122 regulator-max-microvolt = <3300000>;
123 enable-active-high;
124 startup-delay-us = <500>;
128 vcc_sdhi1: regulator-vcc-sdhi1 {
129 compatible = "regulator-fixed";
131 regulator-name = "SDHI1 Vcc";
132 regulator-min-microvolt = <3300000>;
133 regulator-max-microvolt = <3300000>;
138 vccq_sdhi1: regulator-vccq-sdhi1 {
139 compatible = "regulator-gpio";
141 regulator-name = "SDHI1 VccQ";
142 regulator-min-microvolt = <1800000>;
143 regulator-max-microvolt = <3300000>;
146 gpios-states = <1>;
152 pinctrl-0 = <&avb_pins>;
153 pinctrl-names = "default";
155 phy-handle = <&phy3>;
156 phy-mode = "gmii";
157 renesas,no-ether-link;
160 phy3: ethernet-phy@3 {
161 compatible = "ethernet-phy-id0022.1622",
162 "ethernet-phy-ieee802.3-c22";
164 micrel,led-mode = <1>;
169 pinctrl-0 = <&can0_pins>;
170 pinctrl-names = "default";
184 touch-interrupt-hog {
185 gpio-hog;
193 pinctrl-0 = <&usb0_pins>;
194 pinctrl-names = "default";
198 pinctrl-0 = <&i2c2_pins>;
199 pinctrl-names = "default";
202 clock-frequency = <400000>;
209 sgtl5000: codec@a {
211 #sound-dai-cells = <0>;
214 VDDA-supply = <®_3p3v>;
215 VDDIO-supply = <®_3p3v>;
216 VDDD-supply = <®_1p5v>;
220 compatible = "edt,edt-ft5406";
222 interrupt-parent = <&gpio2>;
224 vcc-supply = <&vcc_3v3_tft1>;
234 remote-endpoint = <&lvds_receiver_in>;
241 pinctrl-0 = <&usb0_pins>;
242 pinctrl-names = "default";
247 pinctrl-0 = <&usb1_pins>;
248 pinctrl-names = "default";
252 clock-frequency = <100000000>;
289 power-source = <3300>;
295 power-source = <1800>;
315 pinctrl-0 = <&pwm3_pins>;
316 pinctrl-names = "default";
321 pinctrl-0 = <&sound_pins>;
322 pinctrl-names = "default";
326 #sound-dai-cells = <0>;
337 timeout-sec = <60>;
342 pinctrl-0 = <&scif0_pins>;
343 pinctrl-names = "default";
349 pinctrl-0 = <&scifb1_pins>;
350 pinctrl-names = "default";
352 uart-has-rtscts;
357 pinctrl-0 = <&sdhi1_pins>;
358 pinctrl-1 = <&sdhi1_pins_uhs>;
359 pinctrl-names = "default", "state_uhs";
361 vmmc-supply = <&vcc_sdhi1>;
362 vqmmc-supply = <&vccq_sdhi1>;
363 cd-gpios = <&gpio6 14 GPIO_ACTIVE_LOW>;
364 wp-gpios = <&gpio6 15 GPIO_ACTIVE_HIGH>;
365 sd-uhs-sdr50;
370 shared-pin;