Lines Matching +full:mmp2 +full:- +full:clock

1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
8 /dts-v1/;
9 #include "mmp2.dtsi"
10 #include <dt-bindings/gpio/gpio.h>
11 #include <dt-bindings/input/linux-event-codes.h>
12 #include <dt-bindings/interrupt-controller/irq.h>
13 #include <dt-bindings/clock/marvell,mmp2-audio.h>
16 	model = "OLPC XO-1.75";
17 	compatible = "olpc,xo-1.75", "mrvl,mmp2";
20 		#address-cells = <1>;
21 		#size-cells = <1>;
25 			compatible = "simple-framebuffer";
42 	gpio-keys {
43 		compatible = "gpio-keys";
48 			linux,input-type = <EV_SW>;
50 			wakeup-source;
54 			label = "E-Book Mode";
56 			linux,input-type = <EV_SW>;
58 			wakeup-source;
63 		compatible = "i2c-gpio";
64 		sda-gpios = <&gpio 109 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
65 		scl-gpios = <&gpio 108 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
66 		#address-cells = <1>;
67 		#size-cells = <0>;
68 		i2c-gpio,timeout-ms = <1000>;
74 			reset-gpios = <&gpio 102 GPIO_ACTIVE_LOW>;
75 			powerdown-gpios = <&gpio 150 GPIO_ACTIVE_LOW>;
77 			clock-names = "xclk";
81 					hsync-active = <1>;
82 					vsync-active = <1>;
83 					remote-endpoint = <&camera0_0>;
90 		compatible = "olpc,xo1.5-battery", "olpc,xo1-battery";
94 		compatible = "regulator-fixed";
95 		regulator-name = "wlan";
96 		regulator-min-microvolt = <3300000>;
97 		regulator-max-microvolt = <3300000>;
99 		enable-active-high;
103 		compatible = "mmc-pwrseq-sd8787";
104 		powerdown-gpios = <&gpio 57 GPIO_ACTIVE_HIGH>;
105 		reset-gpios = <&gpio 58 GPIO_ACTIVE_HIGH>;
108 	sound-card {
109 		compatible = "audio-graph-card";
116 		hp-det-gpio = <&gpio 97 GPIO_ACTIVE_HIGH>;
117 		mic-det-gpio = <&gpio 96 GPIO_ACTIVE_HIGH>;
122 			ap-sp@d4290000 {
123 				#address-cells = <1>;
124 				#size-cells = <0>;
125 				compatible = "olpc,ap-sp";
128 				data-gpios = <&gpio 72 GPIO_ACTIVE_HIGH>;
129 				clk-gpios = <&gpio 71 GPIO_ACTIVE_HIGH>;
157 	clock-frequency = <50000000>;
158 	no-1-8-v;
159 	mrvl,clk-delay-cycles = <31>;
160 	broken-cd;
165 	clock-frequency = <50000000>;
166 	no-1-8-v;
167 	bus-width = <4>;
168 	non-removable;
169 	broken-cd;
170 	wakeup-source;
171 	keep-power-in-suspend;
172 	mmc-pwrseq = <&wlan_pwrseq>;
173 	vmmc-supply = <&wlan_reg>;
178 	clock-frequency = <50000000>;
179 	no-1-8-v;
180 	bus-width = <8>;
181 	non-removable;
182 	broken-cd;
183 	mrvl,clk-delay-cycles = <31>;
190 	audio-codec@1a {
197 				mclk-fs = <256>;
199 				remote-endpoint = <&sspa0_0>;
226 	#address-cells = <0>;
227 	spi-slave;
229 	ready-gpios = <&gpio 125 GPIO_ACTIVE_HIGH>;
232 		compatible = "olpc,xo1.75-ec";
233 		spi-cpha;
234 		cmd-gpios = <&gpio 155 GPIO_ACTIVE_HIGH>;
243 			remote-endpoint = <&ov7670_0>;
263 	dma-names = "tx", "rx";
267 			remote-endpoint = <&rt5631_0>;
268 			frame-master;
269 			bitclock-master;
270 			dai-format = "i2s";