Lines Matching +full:adt7476 +full:- +full:d

1 // SPDX-License-Identifier: (GPL-2.0 OR MIT)
4  (x530/AT-GS980MX)
9 /dts-v1/;
10 #include "armada-385.dtsi"
12 #include <dt-bindings/gpio/gpio.h>
15 	model = "x530/AT-GS980MX";
19 		stdout-path = "serial1:115200n8";
32 		internal-regs {
34 				pinctrl-names = "default";
35 				pinctrl-0 = <&i2c0_pins>;
40 				pinctrl-names = "default";
41 				pinctrl-0 = <&uart0_pins>;
54 	reset-gpios = <&gpio1 23 GPIO_ACTIVE_LOW>;
55 	reset-delay-us = <400000>;
63 	compatible = "marvell,mvebu-devbus";
66 	devbus,bus-width    = <8>;
67 	devbus,turn-off-ps  = <60000>;
68 	devbus,badr-skew-ps = <0>;
69 	devbus,acc-first-ps = <124000>;
70 	devbus,acc-next-ps  = <248000>;
71 	devbus,rd-setup-ps  = <0>;
72 	devbus,rd-hold-ps   = <0>;
75 	devbus,sync-enable = <0>;
76 	devbus,wr-high-ps  = <60000>;
77 	devbus,wr-low-ps   = <60000>;
78 	devbus,ale-wr-ps   = <60000>;
83 		compatible = "mtd-ram";
85 		bank-width = <1>;
91 	i2c0_gpio_pins: i2c-gpio-pins-0 {
98 	clock-frequency = <100000>;
101 	pinctrl-names = "default", "gpio";
102 	pinctrl-0 = <&i2c0_pins>;
103 	pinctrl-1 = <&i2c0_gpio_pins>;
104 	scl-gpio = <&gpio0 2 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
105 	sda-gpio = <&gpio0 3 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>;
108 		#address-cells = <1>;
109 		#size-cells = <0>;
112 		i2c-mux-idle-disconnect;
115 			#address-cells = <1>;
116 			#size-cells = <0>;
121 			#address-cells = <1>;
122 			#size-cells = <0>;
126 				compatible = "adi,adt7476";
130 			adt7476_2d: hwmon@2d {
131 				compatible = "adi,adt7476";
137 			#address-cells = <1>;
138 			#size-cells = <0>;
148 			#address-cells = <1>;
149 			#size-cells = <0>;
154 				gpio-controller;
155 				#gpio-cells = <2>;
167 	pinctrl-names = "default";
168 	pinctrl-0 = <&spi1_pins>;
172 		#address-cells = <1>;
173 		#size-cells = <1>;
174 		compatible = "jedec,spi-nor";
176 		spi-max-frequency = <54000000>;
179 			compatible = "fixed-partitions";
180 			#address-cells = <1>;
181 			#size-cells = <1>;
184 				label = "u-boot";
188 				label = "u-boot-env";
207 		label = "pxa3xx_nand-0";
208 		nand-rb = <0>;
209 		nand-on-flash-bbt;
210 		nand-ecc-strength = <4>;
211 		nand-ecc-step-size = <512>;
213 		marvell,nand-enable-arbiter;
216 			compatible = "fixed-partitions";
217 			#address-cells = <1>;
218 			#size-cells = <1>;
230 				label = "nand-bbt";