Lines Matching +full:vga +full:- +full:connector
4 * Maxime Ripard <maxime.ripard@free-electrons.com>
6 * This file is dual-licensed: you can use it either under the terms
45 /dts-v1/;
46 #include "sun5i-a13.dtsi"
47 #include "sunxi-common-regulators.dtsi"
49 #include <dt-bindings/gpio/gpio.h>
50 #include <dt-bindings/input/input.h>
53 model = "Olimex A13-Olinuxino";
54 compatible = "olimex,a13-olinuxino", "allwinner,sun5i-a13";
61 stdout-path = "serial0:115200n8";
65 compatible = "gpio-leds";
66 pinctrl-names = "default";
67 pinctrl-0 = <&led_pins_olinuxino>;
71 default-state = "on";
76 compatible = "dumb-vga-dac";
79 #address-cells = <1>;
80 #size-cells = <0>;
86 remote-endpoint = <&tcon0_out_vga>;
94 remote-endpoint = <&vga_con_in>;
100 vga {
101 compatible = "vga-connector";
105 remote-endpoint = <&vga_bridge_out>;
127 compatible = "x-powers,axp209";
131 interrupt-controller;
132 #interrupt-cells = <1>;
145 vref-supply = <®_vcc3v0>;
148 button-191 {
155 button-392 {
162 button-601 {
169 button-795 {
176 button-987 {
185 vmmc-supply = <®_vcc3v3>;
186 bus-width = <4>;
187 cd-gpios = <&pio 6 0 GPIO_ACTIVE_LOW>; /* PG0 */
200 led_pins_olinuxino: led-pin {
203 drive-strength = <20>;
218 pinctrl-names = "default";
219 pinctrl-0 = <&lcd_rgb666_pins>;
226 remote-endpoint = <&vga_bridge_in>;
231 pinctrl-names = "default";
232 pinctrl-0 = <&uart1_pg_pins>;
242 usb0_id_det-gpios = <&pio 6 2 (GPIO_ACTIVE_HIGH | GPIO_PULL_UP)>; /* PG2 */
243 usb0_vbus_det-gpios = <&pio 6 1 (GPIO_ACTIVE_HIGH | GPIO_PULL_DOWN)>; /* PG1 */
244 usb0_vbus-supply = <®_usb0_vbus>;
245 usb1_vbus-supply = <®_usb1_vbus>;