Lines Matching +full:button +full:- +full:191
4 * Maxime Ripard <maxime.ripard@free-electrons.com>
6 * This file is dual-licensed: you can use it either under the terms
45 /dts-v1/;
46 #include "sun5i-a10s.dtsi"
47 #include "sunxi-common-regulators.dtsi"
49 #include <dt-bindings/gpio/gpio.h>
50 #include <dt-bindings/input/input.h>
53 model = "Olimex A10s-Olinuxino Micro";
54 compatible = "olimex,a10s-olinuxino-micro", "allwinner,sun5i-a10s";
63 stdout-path = "serial0:115200n8";
67 compatible = "hdmi-connector";
72 remote-endpoint = <&hdmi_out_con>;
78 compatible = "gpio-leds";
79 pinctrl-names = "default";
80 pinctrl-0 = <&led_pins_olinuxino>;
83 label = "a10s-olinuxino-micro:green:usr";
85 default-state = "on";
99 pinctrl-names = "default";
100 pinctrl-0 = <&emac_pa_pins>;
101 phy-handle = <&phy1>;
115 remote-endpoint = <&hdmi_con_in>;
137 read-only;
146 vref-supply = <®_vcc3v0>;
149 button-191 {
156 button-392 {
163 button-601 {
170 button-795 {
177 button-987 {
188 phy1: ethernet-phy@1 {
194 vmmc-supply = <®_vcc3v3>;
195 bus-width = <4>;
196 cd-gpios = <&pio 6 1 GPIO_ACTIVE_LOW>; /* PG1 */
201 vmmc-supply = <®_vcc3v3>;
202 bus-width = <4>;
203 cd-gpios = <&pio 6 13 GPIO_ACTIVE_LOW>; /* PG13 */
216 led_pins_olinuxino: led-pin {
219 drive-strength = <20>;
234 pinctrl-names = "default";
235 pinctrl-0 = <&spi2_pb_pins>,
245 pinctrl-names = "default";
246 pinctrl-0 = <&uart0_pb_pins>;
251 pinctrl-names = "default";
252 pinctrl-0 = <&uart2_pc_pins>;
257 pinctrl-names = "default";
258 pinctrl-0 = <&uart3_pg_pins>;
268 usb0_id_det-gpios = <&pio 6 12 (GPIO_ACTIVE_HIGH | GPIO_PULL_UP)>; /* PG12 */
269 usb0_vbus-supply = <®_usb0_vbus>;
270 usb1_vbus-supply = <®_usb1_vbus>;