Lines Matching +full:spdif +full:- +full:out
6 * This file is dual-licensed: you can use it either under the terms
41 * FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR
45 /dts-v1/;
46 #include "sun4i-a10.dtsi"
47 #include "sunxi-common-regulators.dtsi"
49 #include <dt-bindings/gpio/gpio.h>
53 compatible = "mele,a1000", "allwinner,sun4i-a10";
60 stdout-path = "serial0:115200n8";
63 hdmi-connector {
64 compatible = "hdmi-connector";
69 remote-endpoint = <&hdmi_out_con>;
75 compatible = "gpio-leds";
77 led-0 {
82 led-1 {
85 default-state = "on";
89 reg_emac_3v3: emac-3v3 {
90 compatible = "regulator-fixed";
91 regulator-name = "emac-3v3";
92 regulator-min-microvolt = <3300000>;
93 regulator-max-microvolt = <3300000>;
94 startup-delay-us = <20000>;
95 enable-active-high;
100 compatible = "simple-audio-card";
101 simple-audio-card,name = "On-board SPDIF";
103 simple-audio-card,cpu {
104 sound-dai = <&spdif>;
107 simple-audio-card,codec {
108 sound-dai = <&spdif_out>;
112 spdif_out: spdif-out {
113 #sound-dai-cells = <0>;
114 compatible = "linux,spdif-dit";
127 cpu-supply = <®_dcdc2>;
139 phy-handle = <&phy1>;
157 remote-endpoint = <&hdmi_con_in>;
165 compatible = "x-powers,axp209";
169 interrupt-controller;
170 #interrupt-cells = <1>;
175 pinctrl-names = "default";
176 pinctrl-0 = <&ir0_rx_pins>;
181 phy-supply = <®_emac_3v3>;
184 phy1: ethernet-phy@1 {
190 vmmc-supply = <®_vcc3v3>;
191 bus-width = <4>;
192 cd-gpios = <&pio 7 1 GPIO_ACTIVE_LOW>; /* PH1 */
207 regulator-always-on;
208 regulator-min-microvolt = <1000000>;
209 regulator-max-microvolt = <1400000>;
210 regulator-name = "vdd-cpu";
214 regulator-always-on;
215 regulator-min-microvolt = <1000000>;
216 regulator-max-microvolt = <1250000>;
217 regulator-name = "vdd-int-dll";
221 regulator-name = "vdd-rtc";
225 regulator-always-on;
226 regulator-min-microvolt = <3000000>;
227 regulator-max-microvolt = <3000000>;
228 regulator-name = "avcc";
239 &spdif {
240 pinctrl-names = "default";
241 pinctrl-0 = <&spdif_tx_pin>;
246 pinctrl-names = "default";
247 pinctrl-0 = <&uart0_pb_pins>;
252 usb1_vbus-supply = <®_usb1_vbus>;
253 usb2_vbus-supply = <®_usb2_vbus>;