Lines Matching +full:high +full:- +full:resolution
10 Each IP-core has a set of parameters which the FPGA designer can use to
20 properties of the device node. In general, device nodes for IP-cores
23 (name): (generic-name)@(base-address) {
24 compatible = "xlnx,(ip-core-name)-(HW_VER)"
27 interrupt-parent = <&interrupt-controller-phandle>;
29 xlnx,(parameter1) = "(string-value)";
30 xlnx,(parameter2) = <(int-value)>;
33 (generic-name): an open firmware-style name that describes the
36 (ip-core-name): the name of the ip block (given after the BEGIN
38 and all underscores '_' converted to dashes '-'.
43 converted to dashes '-'.
46 (size): the address range size (often C_HIGHADDR - C_BASEADDR + 1).
78 compatible = "xlnx,opb-uartlite-1.00.b";
80 interrupt-parent = <&opb_intc_0>;
82 current-speed = <d#115200>; // standard serial device prop
83 clock-frequency = <d#50000000>; // standard serial device prop
84 xlnx,data-bits = <8>;
85 xlnx,odd-parity = <0>;
86 xlnx,use-parity = <0>;
98 - resolution = <xres yres> : pixel resolution of framebuffer. Some
99 implementations use a different resolution.
101 - virt-resolution = <xvirt yvirt> : Size of framebuffer in memory.
103 - rotate-display (empty) : rotate display 180 degrees.
112 - 8-bit (empty) : Set this property for SystemACE in 8 bit mode
117 listed above, nodes for these devices should include a phy-handle
119 like local-mac-address.
126 - current-speed : Baud rate of uartlite
137 - xlnx,family : The family of the FPGA, necessary since the
141 - compatible : should contain "xlnx,xps-hwicap-1.00.a" or
142 "xlnx,opb-hwicap-1.00.b".
150 - clock-frequency : Frequency of the clock input
151 - reg-offset : A value of 3 is required
152 - reg-shift : A value of 2 is required
157 base address for the EHCI registers, and it is always a big-endian
158 USB Host controller. The hardware can be configured as high speed only,
159 or high speed/full speed hybrid.
162 - xlnx,support-usb-fs: A value 0 means the core is built as high speed