Lines Matching +full:board +full:- +full:specific

6 Required SoC Specific Properties:
8 - compatible: should be one of the following.
9     - samsung,s3c2443-spi: for s3c2443, s3c2416 and s3c2450 platforms
10     - samsung,s3c6410-spi: for s3c6410 platforms
11     - samsung,s5pv210-spi: for s5pv210 and s5pc110 platforms
12     - samsung,exynos5433-spi: for exynos5433 compatible controllers
13     - samsung,exynos7-spi: for exynos7 platforms <DEPRECATED>
15 - reg: physical base address of the controller and length of memory mapped
18 - interrupts: The interrupt number to the cpu. The interrupt specifier format
21 - dmas : Two or more DMA channel specifiers following the convention outlined
24 - dma-names: Names for the dma channels. There must be at least one channel
27 - clocks: specifies the clock IDs provided to the SPI controller; they are
31 - clock-names: string names of the clocks in the 'clocks' property; for all the
33   "samsung,spi-src-clk"), while Exynos5433 should specify a third clock
36 Required Board Specific Properties:
38 - #address-cells: should be 1.
39 - #size-cells: should be 0.
41 Optional Board Specific Properties:
43 - samsung,spi-src-clk: If the spi controller includes a internal clock mux to
48 - num-cs: Specifies the number of chip select lines supported. If
51 - cs-gpios: should specify GPIOs used for chipselects (see spi-bus.txt)
53 - no-cs-readback: the CS line is disconnected, therefore the device should not
56 SPI Controller specific data in SPI slave nodes:
58 - The spi slave nodes should provide the following information which is required
61   - samsung,spi-feedback-delay: The sampling phase shift to be applied on the
65       - 0: No phase shift.
66       - 1: 90 degree phase shift sampling.
67       - 2: 180 degree phase shift sampling.
68       - 3: 270 degree phase shift sampling.
72 - All the SPI controller nodes should be represented in the aliases node using
78 - SoC Specific Portion:
81 		compatible = "samsung,exynos4210-spi";
86 		dma-names = "tx", "rx";
87 		#address-cells = <1>;
88 		#size-cells = <0>;
91 - Board Specific Portion:
94 		#address-cells = <1>;
95 		#size-cells = <0>;
96 		pinctrl-names = "default";
97 		pinctrl-0 = <&spi0_bus>;
98 		cs-gpios = <&gpa2 5 0>;
101 			#address-cells = <1>;
102 			#size-cells = <1>;
105 			spi-max-frequency = <10000>;
107 			controller-data {
108 				samsung,spi-feedback-delay = <0>;
112 				label = "U-Boot";
114 				read-only;