Lines Matching +full:can +full:- +full:clock +full:- +full:select

4 and an input FIFO) for serial peripheral interface (SPI) mini-core.
10 - compatible:     Should contain:
11 		  "qcom,spi-qup-v1.1.1" for 8660, 8960 and 8064.
12 		  "qcom,spi-qup-v2.1.1" for 8974 and later
13 		  "qcom,spi-qup-v2.2.1" for 8974 v2 and later.
15 - reg:            Should contain base register location and length
16 - interrupts:     Interrupt number used by this controller
18 - clocks:         Should contain the core clock and the AHB clock.
19 - clock-names:    Should be "core" for the core clock and "iface" for the
20                   AHB clock.
22 - #address-cells: Number of cells required to define a chip select
24 - #size-cells:    Should be zero.
27 - spi-max-frequency: Specifies maximum SPI clock frequency,
28                      Units - Hz. Definition as per
29                      Documentation/devicetree/bindings/spi/spi-bus.txt
30 - num-cs:	total number of chipselects
31 - cs-gpios:	should specify GPIOs used for chipselects.
34 		select can be used.
36 - dmas:         Two DMA channel specifiers following the convention outlined
38 - dma-names:    Names for the dma channels, if present. There must be at
42 SPI slave nodes must be children of the SPI master node and can contain
43 properties described in Documentation/devicetree/bindings/spi/spi-bus.txt
49 		compatible = "qcom,spi-qup-v2";
50 		#address-cells = <1>;
51 		#size-cells = <0>;
54 		spi-max-frequency = <19200000>;
57 		clock-names = "core", "iface";
60 		dma-names = "rx", "tx";
62 		pinctrl-names = "default";
63 		pinctrl-0 = <&spi8_default>;
66 			compatible = "arm,pl022-dummy";
67 			#address-cells = <1>;
68 			#size-cells = <1>;
69 			reg = <0>; /* Chip select 0 */
70 			spi-max-frequency = <19200000>;
71 			spi-cpol;
75 			compatible = "arm,pl022-dummy";
76 			#address-cells = <1>;
77 			#size-cells = <1>;
78 			reg = <1>; /* Chip select 1 */
79 			spi-max-frequency = <9600000>;
80 			spi-cpha;
84 			compatible = "arm,pl022-dummy";
85 			#address-cells = <1>;
86 			#size-cells = <1>;
87 			reg = <2>; /* Chip select 2 */
88 			spi-max-frequency = <19200000>;
89 			spi-cpol;
90 			spi-cpha;
94 			compatible = "arm,pl022-dummy";
95 			#address-cells = <1>;
96 			#size-cells = <1>;
97 			reg = <3>; /* Chip select 3 */
98 			spi-max-frequency = <19200000>;
99 			spi-cpol;
100 			spi-cpha;
101 			spi-cs-high;