Lines Matching +full:imx35 +full:- +full:sdma
5 - compatible :
6 - "fsl,imx1-cspi" for SPI compatible with the one integrated on i.MX1
7 - "fsl,imx21-cspi" for SPI compatible with the one integrated on i.MX21
8 - "fsl,imx27-cspi" for SPI compatible with the one integrated on i.MX27
9 - "fsl,imx31-cspi" for SPI compatible with the one integrated on i.MX31
10 - "fsl,imx35-cspi" for SPI compatible with the one integrated on i.MX35
11 - "fsl,imx51-ecspi" for SPI compatible with the one integrated on i.MX51
12 - "fsl,imx53-ecspi" for SPI compatible with the one integrated on i.MX53 and later Soc
13 - "fsl,imx8mq-ecspi" for SPI compatible with the one integrated on i.MX8MQ
14 - "fsl,imx8mm-ecspi" for SPI compatible with the one integrated on i.MX8MM
15 - "fsl,imx8mn-ecspi" for SPI compatible with the one integrated on i.MX8MN
16 - "fsl,imx8mp-ecspi" for SPI compatible with the one integrated on i.MX8MP
17 - reg : Offset and length of the register set for the device
18 - interrupts : Should contain CSPI/eCSPI interrupt
19 - clocks : Clock specifiers for both ipg and per clocks.
20 - clock-names : Clock names should include both "ipg" and "per"
22 Documentation/devicetree/bindings/clock/clock-bindings.txt
25 - cs-gpios : GPIOs to use as chip selects, see spi-bus.txt. While the native chip
31 - num-cs : Number of total chip selects, see spi-bus.txt.
32 - dmas: DMA specifiers for tx and rx dma. See the DMA client binding,
34 - dma-names: DMA request names, if present, should include "tx" and "rx".
35 - fsl,spi-rdy-drctl: Integer, representing the value of DRCTL, the register
37 the SPI_READY mode-flag needs to be set too.
38 Valid values are: 0 (disabled), 1 (edge-triggered burst) and 2 (level-triggered burst).
41 - fsl,spi-num-chipselects : Contains the number of the chipselect
46 #address-cells = <1>;
47 #size-cells = <0>;
48 compatible = "fsl,imx51-ecspi";
51 cs-gpios = <&gpio3 24 0>, /* GPIO3_24 */
53 dmas = <&sdma 3 7 1>, <&sdma 4 7 2>;
54 dma-names = "rx", "tx";
55 fsl,spi-rdy-drctl = <1>;