Lines Matching +full:interrupt +full:- +full:driven

8   - compatible : One of "wlf,wm1811", "wlf,wm8994" or "wlf,wm8958".
10   - reg : the I2C address of the device for I2C, the chip select
13   - gpio-controller : Indicates this device is a GPIO controller.
14   - #gpio-cells : Must be 2. The first cell is the pin number and the
17   - power supplies for the device, as covered in
20     - for wlf,wm1811 and wlf,wm8958:
21       AVDD1-supply, AVDD2-supply, DBVDD1-supply, DBVDD2-supply, DBVDD3-supply,
22       DCVDD-supply, CPVDD-supply, SPKVDD1-supply, SPKVDD2-supply
23     - for wlf,wm8994:
24       AVDD1-supply, AVDD2-supply, DBVDD-supply, DCVDD-supply, CPVDD-supply,
25       SPKVDD1-supply, SPKVDD2-supply
29   - interrupts : The interrupt line the IRQ signal for the device is
31     of the interrupt related properties should be specified.
32   - interrupt-controller : These devices contain interrupt controllers
33     and may provide interrupt services to other devices if they have an
34     interrupt line connected.
35   - #interrupt-cells: the number of cells to describe an IRQ, this should be 2.
38     Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
40   - clocks : A list of up to two phandle and clock specifier pairs
41   - clock-names : A list of clock names sorted in the same order as clocks.
44   - wlf,gpio-cfg : A list of GPIO configuration register values. If absent,
49   - wlf,micbias-cfg : Two MICBIAS register values for WM1811 or
52   - wlf,ldo1ena : GPIO specifier for control of LDO1ENA input to device.
53   - wlf,ldo2ena : GPIO specifier for control of LDO2ENA input to device.
55   - wlf,lineout1-se : If present LINEOUT1 is in single ended mode.
56   - wlf,lineout2-se : If present LINEOUT2 is in single ended mode.
58   - wlf,lineout1-feedback : If present LINEOUT1 has common mode feedback
60   - wlf,lineout2-feedback : If present LINEOUT2 has common mode feedback
63   - wlf,ldoena-always-driven : If present LDOENA is always driven.
65   - wlf,spkmode-pu : If present enable the internal pull-up resistor on
68   - wlf,csnaddr-pd : If present enable the internal pull-down resistor on
100 	gpio-controller;
101 	#gpio-cells = <2>;
103 	lineout1-se;
105 	AVDD1-supply = <&regulator>;
106 	AVDD2-supply = <&regulator>;
107 	CPVDD-supply = <&regulator>;
108 	DBVDD-supply = <&regulator>;
109 	DCVDD-supply = <&regulator>;
110 	SPKVDD1-supply = <&regulator>;
111 	SPKVDD2-supply = <&regulator>;