Lines Matching +full:spkvdd1 +full:- +full:supply

8   - compatible : One of "wlf,wm1811", "wlf,wm8994" or "wlf,wm8958".
10 - reg : the I2C address of the device for I2C, the chip select
13 - gpio-controller : Indicates this device is a GPIO controller.
14 - #gpio-cells : Must be 2. The first cell is the pin number and the
17 - power supplies for the device, as covered in
20 - for wlf,wm1811 and wlf,wm8958:
21 AVDD1-supply, AVDD2-supply, DBVDD1-supply, DBVDD2-supply, DBVDD3-supply,
22 DCVDD-supply, CPVDD-supply, SPKVDD1-supply, SPKVDD2-supply
23 - for wlf,wm8994:
24 AVDD1-supply, AVDD2-supply, DBVDD-supply, DCVDD-supply, CPVDD-supply,
25 SPKVDD1-supply, SPKVDD2-supply
29 - interrupts : The interrupt line the IRQ signal for the device is
32 - interrupt-controller : These devices contain interrupt controllers
35 - #interrupt-cells: the number of cells to describe an IRQ, this should be 2.
38 Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
40 - clocks : A list of up to two phandle and clock specifier pairs
41 - clock-names : A list of clock names sorted in the same order as clocks.
44 - wlf,gpio-cfg : A list of GPIO configuration register values. If absent,
49 - wlf,micbias-cfg : Two MICBIAS register values for WM1811 or
52 - wlf,ldo1ena : GPIO specifier for control of LDO1ENA input to device.
53 - wlf,ldo2ena : GPIO specifier for control of LDO2ENA input to device.
55 - wlf,lineout1-se : If present LINEOUT1 is in single ended mode.
56 - wlf,lineout2-se : If present LINEOUT2 is in single ended mode.
58 - wlf,lineout1-feedback : If present LINEOUT1 has common mode feedback
60 - wlf,lineout2-feedback : If present LINEOUT2 has common mode feedback
63 - wlf,ldoena-always-driven : If present LDOENA is always driven.
65 - wlf,spkmode-pu : If present enable the internal pull-up resistor on
68 - wlf,csnaddr-pd : If present enable the internal pull-down resistor on
100 gpio-controller;
101 #gpio-cells = <2>;
103 lineout1-se;
105 AVDD1-supply = <&regulator>;
106 AVDD2-supply = <&regulator>;
107 CPVDD-supply = <&regulator>;
108 DBVDD-supply = <&regulator>;
109 DCVDD-supply = <&regulator>;
110 SPKVDD1-supply = <&regulator>;
111 SPKVDD2-supply = <&regulator>;