Lines Matching refs:If
9 - reset-gpios: a GPIO spec for the reset pin. If specified, it will be
12 - power-down-gpios: a GPIO spec for the power down pin. If specified,
27 If parameter is missing, mode 0 will be enabled.
36 If parameter is missing, channel 1 is chosen.
40 If present, thermal warning recovery is enabled.
43 If present, thermal warning adjustment is enabled.
46 If present, then fault recovery will be enabled.
64 If present, overcurrent warning adjustment is enabled.
67 If present, then MPCC bits are used for MPC coefficients,
71 If present, power bridge correction for THD reduction near maximum
75 If present, FFX mode runs in AM reduction mode, otherwise normal
79 If present, PWM speed mode run on odd speed mode (341.3 kHz) on all
80 channels. If not present, normal PWM spped mode (384 kHz) will be used.
83 If present, distortion compensation variable uses DCC coefficient.
84 If not present, preset DC coefficient is used.
87 If present, automatic invalid input detect mute is enabled.
90 If present, a mute output will be activated in ase the volume will
94 If present, the bridge will be switched off immediately after the
99 If present, the noise-shaping technique on the DC cutoff filter are
103 If present, the power-down pin and I2C power-down functions will
108 If present, the bridge power-down time will be divided by the provided
109 value. If not specified, a divider of 1 will be used. Allowed values