Lines Matching +full:ch3 +full:- +full:0
7 - compatible: "st,sta32x"
8 - reg: the I2C address of the device for I2C
9 - reset-gpios: a GPIO spec for the reset pin. If specified, it will be
12 - power-down-gpios: a GPIO spec for the power down pin. If specified,
16 - Vdda-supply: regulator spec, providing 3.3V
17 - Vdd3-supply: regulator spec, providing 3.3V
18 - Vcc-supply: regulator spec, providing 5V - 26V
22 - clocks, clock-names: Clock specifier for XTI input clock.
24 and disabled when it is removed. The 'clock-names' must be set to 'xti'.
26 - st,output-conf: number, Selects the output configuration:
27 0: 2-channel (full-bridge) power, 2-channel data-out
28 1: 2 (half-bridge). 1 (full-bridge) on-board power
29 2: 2 Channel (Full-Bridge) Power, 1 Channel FFX
30 3: 1 Channel Mono-Parallel
31 If parameter is missing, mode 0 will be enabled.
34 - st,ch1-output-mapping: Channel 1 output mapping
35 - st,ch2-output-mapping: Channel 2 output mapping
36 - st,ch3-output-mapping: Channel 3 output mapping
37 0: Channel 1
43 - st,thermal-warning-recover:
46 - st,fault-detect-recovery:
49 - st,thermal-warning-adjustment:
52 - st,fault-detect-recovery:
55 - st,drop-compensation-ns: number
56 Only required for "st,ffx-power-output-mode" ==
57 "variable-drop-compensation".
59 The value must be in the range of 0..300, and only
62 - st,max-power-use-mpcc:
66 - st,max-power-corr:
70 - st,am-reduction-mode:
74 - st,odd-pwm-speed-mode:
78 - st,invalid-input-detect-mute:
85 reg = <0x1c>;
87 clock-names = "xti";
88 reset-gpios = <&gpio1 19 0>;
89 power-down-gpios = <&gpio1 16 0>;
90 st,output-conf = /bits/ 8 <0x3>; // set output to 2-channel
91 // (full-bridge) power,
92 // 2-channel data-out
93 st,ch1-output-mapping = /bits/ 8 <0>; // set channel 1 output ch 1
94 st,ch2-output-mapping = /bits/ 8 <0>; // set channel 2 output ch 1
95 st,ch3-output-mapping = /bits/ 8 <0>; // set channel 3 output ch 1
96 st,max-power-correction; // enables power bridge
99 st,invalid-input-detect-mute; // mute if no valid digital