Lines Matching +full:i2s +full:- +full:rx

1 * Atmel I2S controller
4 - compatible:     Should be "atmel,sama5d2-i2s".
5 - reg:            Should be the physical base address of the controller and the
7 - interrupts:     Should contain the interrupt for the controller.
8 - dmas:           Should be one per channel name listed in the dma-names property,
9                   as described in atmel-dma.txt and dma.txt files.
10 - dma-names:      Two dmas have to be defined, "tx" and "rx".
11                   This IP also supports one shared channel for both rx and tx;
12                   if this mode is used, one "rx-tx" name must be used.
13 - clocks:         Must contain an entry for each entry in clock-names.
14                   Please refer to clock-bindings.txt.
15 - clock-names:    Should be one of each entry matching the clocks phandles list:
16                   - "pclk" (peripheral clock) Required.
17                   - "gclk" (generated clock) Optional (1).
18                   - "muxclk" (I2S mux clock) Optional (1).
21 - pinctrl-0:      Should specify pin control groups used for this controller.
22 - princtrl-names: Should contain only one value - "default".
25 (1) : Only the peripheral clock is required. The generated clock and the I2S
31 	i2s@f8050000 {
32 		compatible = "atmel,sama5d2-i2s";
41 		dma-names = "tx", "rx";
43 		clock-names = "pclk", "gclk", "muxclk";
44 		pinctrl-names = "default";
45 		pinctrl-0 = <&pinctrl_i2s0_default>;