Lines Matching +full:enable +full:- +full:modem +full:- +full:interrupt
4 - compatible : should be,
5 "nvidia,tegra20-hsuart" for Tegra20,
6 "nvidia,tegra30-hsuart" for Tegra30,
7 "nvidia,tegra186-hsuart" for Tegra186,
8 "nvidia,tegra194-hsuart" for Tegra194.
10 - reg: Should contain UART controller registers location and length.
11 - interrupts: Should contain UART controller interrupts.
12 - clocks: Must contain one entry, for the module clock.
13 See ../clocks/clock-bindings.txt for details.
14 - resets : Must contain an entry for each entry in reset-names.
16 - reset-names : Must include the following entries:
17 - serial
18 - dmas : Must contain an entry for each entry in dma-names.
20 - dma-names : Must include the following entries:
21 - rx
22 - tx
25 - nvidia,enable-modem-interrupt: Enable modem interrupts. Should be enable
27 - nvidia,adjust-baud-rates: List of entries providing percentage of baud rate
38 -4 to +4 %. All Tegra devices till Tegra210 had this support. However,
40 is 0% to +4% in 1-stop config. Otherwise, the received data will have
46 Tx baud rate observed. To do this we use nvidia,adjust-baud-rates
56 nvidia,adjust-baud-rates = <0 9600 100>,
62 compatible = "nvidia,tegra30-hsuart", "nvidia,tegra20-hsuart";
64 reg-shift = <2>;
66 nvidia,enable-modem-interrupt;
69 reset-names = "serial";
71 dma-names = "rx", "tx";
72 nvidia,adjust-baud-rates = <1000000 4000000 136>; /* 1.36% shift */