Lines Matching +full:charging +full:- +full:current

1 Binding for TI bq24250/bq24251/bq24257 Li-Ion Charger
4 - compatible: Should contain one of the following:
8 - reg: integer, i2c address of the device.
9 - interrupts: Interrupt mapping for GPIO IRQ (configure for both edges). Use in
10     conjunction with "interrupt-parent".
11 - ti,battery-regulation-voltage: integer, maximum charging voltage in uV.
12 - ti,charge-current: integer, maximum charging current in uA.
13 - ti,termination-current: integer, charge will be terminated when current in
14     constant-voltage phase drops below this value (in uA).
17 - pg-gpios: GPIO used for connecting the bq2425x device PG (Power Good) pin.
20     state. If this pin is not specified a software-based approach for PG
22 - ti,current-limit: The maximum current to be drawn from the charger's input
23     (in uA). If this property is not specified, the input limit current is
24     set automatically using USB D+/D- signal based charger type detection.
25     If the hardware does not support the D+/D- based detection, a default
27 - ti,ovp-voltage: Configures the over voltage protection voltage (in uV). If
29 - ti,in-dpm-voltage: Configures the threshold input voltage for the dynamic
38 	interrupt-parent = <&gpio1>;
41 	pg-gpios = <&gpio1 28 GPIO_ACTIVE_HIGH>;
43 	ti,battery-regulation-voltage = <4200000>;
44 	ti,charge-current = <1000000>;
45 	ti,termination-current = <50000>;
53 	interrupt-parent = <&gpio1>;
56 	ti,battery-regulation-voltage = <4200000>;
57 	ti,charge-current = <500000>;
58 	ti,termination-current = <50000>;
59 	ti,current-limit = <900000>;
60 	ti,ovp-voltage = <9500000>;
61 	ti,in-dpm-voltage = <4440000>;