Lines Matching +full:inactive +full:- +full:delay

6 'input' is not found, the GPIO line will be driven in the inactive
9 When the power-off handler is called, the gpio is configured as an
11 condition. This will also cause an inactive->active edge condition, so
12 triggering positive edge triggered power off. After a delay of 100ms,
13 the GPIO is set to inactive, thus causing an active->inactive edge,
15 delay the GPIO is driver active again. If the power is still on and
16 the CPU still running after a 3000ms delay, a WARN_ON(1) is emitted.
19 - compatible : should be "gpio-poweroff".
20 - gpios : The GPIO to set high/low, see "gpios property" in
26 - input : Initially configure the GPIO line as an input. Only reconfigure
27   it to an output when the power-off handler is called. If this optional
29   inactive state.
30 - active-delay-ms: Delay (default 100) to wait after driving gpio active
31 - inactive-delay-ms: Delay (default 100) to wait after driving gpio inactive
32 - timeout-ms: Time to wait before asserting a WARN_ON(1). If nothing is
37 gpio-poweroff {
38 	compatible = "gpio-poweroff";
40 	timeout-ms = <3000>;