Lines Matching +full:rzn1 +full:- +full:pinctrl

1 Renesas RZ/N1 SoC Pinctrl node description.
4 -------------------
6 - compatible: SoC-specific compatible string "renesas,<soc-specific>-pinctrl"
7   followed by "renesas,rzn1-pinctrl" as fallback. The SoC-specific compatible
9 	"renesas,r9a06g032-pinctrl" for RZ/N1D
10 	"renesas,r9a06g033-pinctrl" for RZ/N1S
11 - reg: Address base and length of the memory area where the pin controller
13 - clocks: phandle for the clock, see the description of clock-names below.
14 - clock-names: Contains the name of the clock:
18 	pinctrl: pin-controller@40067000 {
19 	    compatible = "renesas,r9a06g032-pinctrl", "renesas,rzn1-pinctrl";
22 	    clock-names = "bus";
25 Sub-nodes
26 ---------
31 - Pin multiplexing sub-nodes:
32   A pin multiplexing sub-node describes how to configure a set of
34   A single sub-node may define several pin configurations.
35   Please refer to pinctrl-bindings.txt to get to know more on generic
38   The allowed generic formats for a pin multiplexing sub-node are the
41   node-1 {
46   node-2 {
47       sub-node-1 {
52       sub-node-2 {
59       sub-node-n {
65   node-3 {
69       sub-node-1 {
76       sub-node-n {
84   pinconfig in node-3 does not apply to the sub-nodes.
86   Client sub-nodes shall refer to pin multiplexing sub-nodes using the phandle
91   client-1 {
93       pinctrl-0 = <&node-1>;
97   client-2 {
99       pinctrl-0 = <&node-2>;
104     - pinmux:
116       <include/dt-bindings/pinctrl/rzn1-pinctrl.h>
123     - bias-disable		- disable any pin bias
124     - bias-pull-up		- pull up the pin with 50 KOhm
125     - bias-pull-down		- pull down the pin with 50 KOhm
126     - bias-high-impedance	- high impedance mode
127     - drive-strength		- sink or source at most 4, 6, 8 or 12 mA
132   &pinctrl {
144   &pinctrl {
150 			bias-pull-up;