Lines Matching +full:mdc +full:- +full:pin

6 - compatible:
9 	Definition: must be "qcom,ipq8074-pinctrl"
11 - reg:
13 	Value type: <prop-encoded-array>
16 - interrupts:
18 	Value type: <prop-encoded-array>
21 - interrupt-controller:
26 - #interrupt-cells:
29 	Definition: must be 2. Specifying the pin number and flags, as defined
30 		    in <dt-bindings/interrupt-controller/irq.h>
32 - gpio-controller:
37 - #gpio-cells:
40 	Definition: must be 2. Specifying the pin number and flags, as defined
41 		    in <dt-bindings/gpio/gpio.h>
43 - gpio-ranges:
47 - gpio-reserved-ranges:
51 Please refer to ../gpio/gpio.txt and ../interrupt-controller/interrupts.txt for
54 Please refer to pinctrl-bindings.txt in this directory for details of the
56 phrase "pin configuration node".
58 The pin configuration nodes act as a container for an arbitrary number of
60 pin, a group, or a list of pins or groups. This configuration can include the
61 mux function to select on those pin(s)/group(s), and various pin configuration
62 parameters, such as pull-up, drive strength, etc.
65 PIN CONFIGURATION NODES:
71 other words, a subnode that lists a mux function but no pin configuration
72 parameters implies no information about any pin configuration parameters.
73 Similarly, a pin subnode that describes a pullup parameter implies no
77 The following generic properties as defined in pinctrl-bindings.txt are valid
78 to specify in a pin configuration subnode:
80 - pins:
82 	Value type: <string-array>
85 		    gpio0-gpio69
87 - function:
104 		    mac1_sa1, mac1_sa2, mac1_sa3, mac2_sa0, mac2_sa1, mdc,
118 - bias-disable:
123 - bias-pull-down:
128 - bias-pull-up:
133 - output-high:
139 - output-low:
145 - drive-strength:
154 		compatible = "qcom,ipq8074-pinctrl";
157 		gpio-controller;
158 		#gpio-cells = <2>;
159 		gpio-ranges = <&tlmm 0 0 70>;
160 		interrupt-controller;
161 		#interrupt-cells = <2>;
163 		uart2: uart2-default {
171 				drive-strength = <4>;
172 				bias-disable;
177 				drive-strength = <2>;
178 				bias-pull-up;