Lines Matching +full:level +full:- +full:shifter

6 - compatible: value should be one of the following.
7 	"mediatek,mt8183-pinctrl", compatible with mt8183 pinctrl.
8 - gpio-controller : Marks the device node as a gpio controller.
9 - #gpio-cells: number of cells in GPIO specifier. Since the generic GPIO
12 - gpio-ranges : gpio valid number range.
13 - reg: physical address base for gpio base registers. There are 10 GPIO
17 - reg-names: gpio base register names. There are 10 gpio base register
20 - interrupt-controller: Marks the device node as an interrupt controller
21 - #interrupt-cells: Should be two.
22 - interrupts : The interrupt outputs to sysirq.
24 Please refer to pinctrl-bindings.txt in this directory for details of the
39 - pinmux: integer array, represents gpio pin number and mux setting.
41     as macros in boot/dts/<soc>-pinfunc.h directly.
44 - GENERIC_PINCONFIG: is the generic pinconfig options to use, bias-disable,
45     bias-pull-down, bias-pull-up, input-enable, input-disable, output-low,
46     output-high, input-schmitt-enable, input-schmitt-disable
47     and drive-strength are valid.
49     Some special pins have extra pull up strength, there are R0 and R1 pull-up
51     10 or 11. So It needs config "mediatek,pull-up-adv" or
52     "mediatek,pull-down-adv" to support arguments for those special pins.
55     mediatek,tdsel: An integer describing the steps for output level shifter
58     mediatek,rdsel: An integer describing the steps for input level shifter
62     When config drive-strength, it can support some arguments, such as
63     MTK_DRIVE_4mA, MTK_DRIVE_6mA, etc. See dt-bindings/pinctrl/mt65xx.h.
74     We can add "mediatek,drive-strength-adv = <XXX>;" to describe the specific
82     So the valid arguments of "mediatek,drive-strength-adv" are from 0 to 7.
86 #include "mt8183-pinfunc.h"
91 		compatible = "mediatek,mt8183-pinctrl";
102 		reg-names = "iocfg0", "iocfg1", "iocfg2",
106 		gpio-controller;
107 		#gpio-cells = <2>;
108 		gpio-ranges = <&pio 0 0 192>;
109 		interrupt-controller;
111 		#interrupt-cells = <2>;
117 				mediatek,pull-up-adv = <3>;
118 				mediatek,drive-strength-adv = <7>;
126 				mediatek,pull-down-adv = <2>;
127 				mediatek,drive-strength-adv = <4>;