Lines Matching +full:bias +full:- +full:pinconf
4 - compatible: Should be one of the following
5 "mediatek,mt7622-pinctrl" for MT7622 SoC
6 "mediatek,mt7629-pinctrl" for MT7629 SoC
7 - reg: offset and length of the pinctrl space
9 - gpio-controller: Marks the device node as a GPIO controller.
10 - #gpio-cells: Should be two. The first cell is the pin number and the
14 - interrupt-controller : Marks the device node as an interrupt controller
16 If the property interrupt-controller is defined, following property is required
17 - reg-names: A string describing the "reg" entries. Must contain "eint".
18 - interrupts : The interrupt output from the controller.
19 - #interrupt-cells: Should be two.
21 Please refer to pinctrl-bindings.txt in this directory for details of the
29 parameters, such as pull-up, slew rate, etc.
32 nodes or pinconf nodes. Each configuration node can consist of multiple nodes
33 describing the pinmux and pinconf options.
40 The following generic properties as defined in pinctrl-bindings.txt are valid
44 - groups: An array of strings. Each string contains the name of a group.
46 - function: A string containing the name of the function to mux to the
49 == pinconf nodes content ==
51 The following generic properties as defined in pinctrl-bindings.txt are valid
52 to specify in a pinconf subnode:
55 - pins: An array of strings. Each string contains the name of a pin.
57 - groups: An array of strings. Each string contains the name of a group.
61 bias-disable, bias-pull, bias-pull-down, input-enable,
62 input-schmitt-enable, input-schmitt-disable, output-enable
63 output-low, output-high, drive-strength, slew-rate
65 Valid arguments for 'slew-rate' are '0' for no slew rate controlled and '1' for
67 Valid arguments for 'drive-strength', 4, 8, 12, or 16 in mA.
69 The following specific properties as defined are valid to specify in a pinconf
73 - mediatek,tdsel: An integer describing the steps for output level shifter duty
76 - mediatek,rdsel: An integer describing the steps for input level shifter duty
89 -----------------------------
204 -------------------------------------------------------------------------
332 -----------------------------
419 ----------------------------------------------------------------
461 compatible = "mediatek,mt7622-pinctrl";
463 gpio-controller;
464 #gpio-cells = <2>;
466 pinctrl_eth_default: eth-default {
467 mux-mdio {
470 drive-strength = <12>;
473 mux-gmac2 {
476 drive-strength = <12>;
479 mux-esw {
482 drive-strength = <8>;
485 conf-mdio {
487 bias-pull-up;