Lines Matching +full:dsp +full:- +full:gpio1

1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10   - patches@opensource.cirrus.com
30     Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt
33   pin-settings:
40       '-pins$':
43           - $ref: pincfg-node.yaml#
44           - $ref: pinmux-node.yaml#
50                     pdmspk2, dmic4, dmic5, dmic6, gpio1, gpio2, gpio3,
63                     dmic6, io, dsp-gpio, irq1, irq2, fll1-clk,
64                     fll1-lock, fll2-clk, fll2-lock, fll3-clk,
65                     fll3-lock, fllao-clk, fllao-lock, opclk,
66                     opclk-async, pwm1, pwm2, spdif, asrc1-in1-lock,
67                     asrc1-in2-lock, asrc2-in1-lock, asrc2-in2-lock,
68                     spkl-short-circuit, spkr-short-circuit,
69                     spk-shutdown, spk-overheat-shutdown,
70                     spk-overheat-warn, timer1-sts, timer2-sts,
71                     timer3-sts, timer4-sts, timer5-sts, timer6-sts,
72                     timer7-sts, timer8-sts, log1-fifo-ne,
73                     log2-fifo-ne, log3-fifo-ne, log4-fifo-ne,
74                     log5-fifo-ne, log6-fifo-ne, log7-fifo-ne,
75                     log8-fifo-ne ]
77           bias-disable: true
79           bias-bus-hold: true
81           bias-pull-up: true
83           bias-pull-down: true
85           drive-push-pull: true
87           drive-open-drain: true
89           drive-strength:
92           input-schmitt-enable: true
94           input-schmitt-disable: true
96           input-debounce: true
98           output-low: true
100           output-high: true
105           - groups
110   - pinctrl-0
111   - pinctrl-names