Lines Matching +full:bcm7445 +full:- +full:sata +full:- +full:phy

1 * Broadcom SATA3 PHY
4 - compatible: should be one or more of
5      "brcm,bcm7216-sata-phy"
6      "brcm,bcm7425-sata-phy"
7      "brcm,bcm7445-sata-phy"
8      "brcm,iproc-ns2-sata-phy"
9      "brcm,iproc-nsp-sata-phy"
10      "brcm,phy-sata3"
11      "brcm,iproc-sr-sata-phy"
12      "brcm,bcm63138-sata-phy"
13 - address-cells: should be 1
14 - size-cells: should be 0
15 - reg: register ranges for the PHY PCB interface
16 - reg-names: should be "phy" and "phy-ctrl"
17      The "phy-ctrl" registers are only required for
18      "brcm,iproc-ns2-sata-phy" and "brcm,iproc-sr-sata-phy".
20 Sub-nodes:
21   Each port's PHY should be represented as a sub-node.
23 Sub-nodes required properties:
24 - reg: the PHY number
25 - phy-cells: generic PHY binding; must be 0
27 Sub-nodes optional properties:
28 - brcm,enable-ssc: use spread spectrum clocking (SSC) on this port
29      This property is not applicable for "brcm,iproc-ns2-sata-phy",
30      "brcm,iproc-nsp-sata-phy" and "brcm,iproc-sr-sata-phy".
32 - brcm,rxaeq-mode: string that indicates the desired RX equalizer
36 	"manual" (brcm,rxaeq-value is used in that case)
38 - brcm,rxaeq-value: when 'rxaeq-mode' is set to "manual", provides the RX
42 	sata-phy@f0458100 {
43 		compatible = "brcm,bcm7445-sata-phy", "brcm,phy-sata3";
45 		reg-names = "phy";
46 		#address-cells = <1>;
47 		#size-cells = <0>;
49 		sata-phy@0 {
51 			#phy-cells = <0>;
54 		sata-phy@1 {
56 			#phy-cells = <0>;