Lines Matching +full:imx28 +full:- +full:auart
3 The QCA7000 is a serial-to-powerline bridge with a host interface which could
13 - compatible : Should be "qca,qca7000"
14 - reg : Should specify the SPI chip select
15 - interrupts : The first cell should specify the index of the source
18 - spi-cpha : Must be set
19 - spi-cpol : Must be set
22 - spi-max-frequency : Maximum frequency of the SPI bus the chip can operate at.
26 - qca,legacy-mode : Set the SPI data transfer of the QCA7000 to legacy mode.
40 #address-cells = <1>;
41 #size-cells = <0>;
42 compatible = "fsl,imx28-spi";
43 pinctrl-names = "default";
44 pinctrl-0 = <&spi2_pins_a>;
49 interrupt-parent = <&gpio3>; /* GPIO Bank 3 */
51 spi-cpha; /* SPI mode: CPHA=1 */
52 spi-cpol; /* SPI mode: CPOL=1 */
53 spi-max-frequency = <8000000>; /* freq: 8 MHz */
54 local-mac-address = [ A0 B0 C0 D0 E0 F0 ];
66 - compatible : Should be "qca,qca7000"
69 - local-mac-address : see ./ethernet.txt
70 - current-speed : current baud rate of QCA7000 which defaults to 115200
77 compatible = "fsl,imx28-auart", "fsl,imx23-auart";
79 pinctrl-names = "default";
80 pinctrl-0 = <&auart0_2pins_a>;
84 local-mac-address = [ A0 B0 C0 D0 E0 F0 ];
85 current-speed = <38400>;