Lines Matching +full:mt7623 +full:- +full:pericfg
1 MediaTek SoC built-in Bluetooth Devices
5 child node of the serial node with BTIF. The dt-bindings details for BTIF
10 - compatible: Must be
11 "mediatek,mt7622-bluetooth": for MT7622 SoC
12 - clocks: Should be the clock specifiers corresponding to the entry in
13 clock-names property.
14 - clock-names: Should contain "ref" entries.
15 - power-domains: Phandle to the power domain that the device is part of
20 compatible = "mediatek,mt7622-btif",
21 "mediatek,mtk-btif";
24 clocks = <&pericfg CLK_PERI_BTIF_PD>;
25 clock-names = "main";
26 reg-shift = <2>;
27 reg-io-width = <4>;
30 compatible = "mediatek,mt7622-bluetooth";
31 power-domains = <&scpsys MT7622_POWER_DOMAIN_WB>;
33 clock-names = "ref";
49 - compatible: Must be
50 "mediatek,mt7663u-bluetooth": for MT7663U device
51 "mediatek,mt7668u-bluetooth": for MT7668U device
52 - vcc-supply: Main voltage regulator
57 - pinctrl-names: Should be "default", "runtime"
58 - pinctrl-0: Should contain UART RXD low when the device is powered up to
60 - pinctrl-1: Should contain UART mode pin ctrl
66 - boot-gpios: GPIO same to the pin as UART RXD and used to keep LOW when
68 - pinctrl-names: Should be "default"
69 - pinctrl-0: Should contain UART mode pin ctrl
73 - reset-gpios: GPIO used to reset the device whose initial state keeps low,
74 if the GPIO is missing, then board-level design should be
76 - clocks: Should be the clock specifiers corresponding to the entry in
77 clock-names property. If the clock is missing, then board-level
79 - clock-names: Should contain "osc" entry for the external oscillator.
80 - current-speed: Current baud rate of the device whose defaults to 921600
84 uart1_pins_boot: uart1-default {
85 pins-dat {
87 output-low;
91 uart1_pins_runtime: uart1-runtime {
92 pins-dat {
99 compatible = "mediatek,mt7623-uart",
100 "mediatek,mt6577-uart";
103 clocks = <&pericfg CLK_PERI_UART1_SEL>,
104 <&pericfg CLK_PERI_UART1>;
105 clock-names = "baud", "bus";
108 compatible = "mediatek,mt7663u-bluetooth";
109 vcc-supply = <®_5v>;
110 reset-gpios = <&pio 24 GPIO_ACTIVE_LOW>;
111 pinctrl-names = "default", "runtime";
112 pinctrl-0 = <&uart1_pins_boot>;
113 pinctrl-1 = <&uart1_pins_runtime>;
114 current-speed = <921600>;