Lines Matching +full:syscon +full:- +full:phy +full:- +full:mode

4 - compatible: should be "hisilicon,hns-dsaf-v1" or "hisilicon,hns-dsaf-v2".
5   "hisilicon,hns-dsaf-v1" is for hip05.
6   "hisilicon,hns-dsaf-v2" is for Hi1610 and Hi1612.
7 - mode: dsa fabric mode string. only support one of dsaf modes like these:
8 		"2port-64vf",
9 		"6port-16rss",
10 		"6port-16vf",
11 		"single-port".
12 - interrupts: should contain the DSA Fabric and rcb interrupt.
13 - reg: specifies base physical address(es) and size of the device registers.
15   only used when subctrl-syscon does not exist). It is recommended using
16   subctrl-syscon rather than this address.
18   serdes-syscon in port node does not exist). It is recommended using
19   serdes-syscon rather than this address.
22   single-port mode.
23 - reg-names: may be ppe-base and(or) dsaf-base. It is used to find the
26 - phy-handle: phy handle of physical port, 0 if not any phy device. It is optional
27   attribute. If port node exists, phy-handle in each port node will be used.
29 - subctrl-syscon: is syscon handle for external interface control register.
30 - reset-field-offset: is offset of reset field. Its value depends on the hardware
32 - buf-size: rx buffer size, should be 16-1024.
33 - desc-num: number of description in TX and RX queue, should be 512, 1024, 2048 or 4096.
35 - port: subnodes of dsaf. A dsaf node may contain several port nodes(Depending
36   on mode of dsaf). Port node contain some attributes listed below:
37 - reg: is physical port index in one dsaf.
38 - phy-handle: phy handle of physical port. It is not required if there isn't
39   phy device. see ethernet.txt [1].
40 - serdes-syscon: is syscon handle for SerDes register.
41 - cpld-syscon: is syscon handle + register offset pair for cpld register. It is
43 - port-rst-offset: is offset of reset field for each port in dsaf. Its value
45 - port-mode-offset: is offset of port mode field for each port in dsaf. Its
47 - mc-mac-mask: mask of multicast address, determines bit in multicast address
54 [1] Documentation/devicetree/bindings/net/phy.txt
59 	compatible = "hisilicon,hns-dsaf-v1";
60 	mode = "6port-16rss";
61 	interrupt-parent = <&mbigen_dsa>;
64 	reg-names = "ppe-base", "dsaf-base";
65 	subctrl-syscon = <&subctrl>;
66 	reset-field-offset = 0;
74 	buf-size = <4096>;
75 	desc-num = <1024>;
76 	dma-coherent;
80 		phy-handle = <&phy0>;
81 		serdes-syscon = <&serdes>;
82 		mc-mac-mask = [ff f0 00 00 00 00];
87                 serdes-syscon = <&serdes>;
88 		mc-mac-mask = [ff f0 00 00 00 00];