Lines Matching +full:tx1 +full:- +full:0
5 - compatible : should be one of "nxp,sja1000", "technologic,sja1000".
7 - reg : should specify the chip select, address offset and size required
8 to map the registers of the SJA1000. The size is usually 0x80.
10 - interrupts: property with a value describing the interrupt source
15 - reg-io-width : Specify the size (in bytes) of the IO accesses that
20 - nxp,external-clock-frequency : Frequency of the external oscillator
25 - nxp,tx-output-mode : operation mode of the TX output control logic:
26 <0x0> : bi-phase output mode
27 <0x1> : normal output mode (default)
28 <0x2> : test output mode
29 <0x3> : clock output mode
31 - nxp,tx-output-config : TX output pin configuration:
32 <0x01> : TX0 invert
33 <0x02> : TX0 pull-down (default)
34 <0x04> : TX0 pull-up
35 <0x06> : TX0 push-pull
36 <0x08> : TX1 invert
37 <0x10> : TX1 pull-down
38 <0x20> : TX1 pull-up
39 <0x30> : TX1 push-pull
41 - nxp,clock-out-frequency : clock frequency in Hz on the CLKOUT pin.
42 If not specified or if the specified value is 0, the CLKOUT pin
45 - nxp,no-comparator-bypass : Allows to disable the CAN input comparator.
53 reg = <3 0x100 0x80>;
54 interrupts = <2 0>;
55 interrupt-parent = <&mpic>;
56 nxp,external-clock-frequency = <16000000>;