Lines Matching +full:two +full:- +full:ethernet

1 APM X-Gene SoC Ethernet nodes
3 Ethernet nodes are defined to describe on-chip ethernet interfaces in
4 APM X-Gene SoC.
6 Required properties for all the ethernet interfaces:
7 - compatible: Should state binding information from the following list,
8   - "apm,xgene-enet":    RGMII based 1G interface
9   - "apm,xgene1-sgenet": SGMII based 1G interface
10   - "apm,xgene1-xgenet": XFI based 10G interface
11 - reg: Address and length of the register set for the device. It contains the
12   information of registers in the same order as described by reg-names
13 - reg-names: Should contain the register set names
14   - "enet_csr": Ethernet control and status register address space
15   - "ring_csr": Descriptor ring control and status register address space
16   - "ring_cmd": Descriptor ring command register address space
17 - interrupts: Two interrupt specifiers can be specified.
18   - First is the Rx interrupt.  This irq is mandatory.
19   - Second is the Tx completion interrupt.
21 - channel: Ethernet to CPU, start channel (prefetch buffer) number
22   - Must map to the first irq and irqs must be sequential
23 - port-id: Port number (0 or 1)
24 - clocks: Reference to the clock entry.
25 - local-mac-address: MAC address assigned to this device
26 - phy-connection-type: Interface type between ethernet device and PHY device
28 Required properties for ethernet interfaces that have external PHY:
29 - phy-handle: Reference to a PHY node connected to this device
31 - mdio: Device tree subnode with the following required properties:
32   - compatible: Must be "apm,xgene-mdio".
33   - #address-cells: Must be <1>.
34   - #size-cells: Must be <0>.
37   - compatible: PHY identifier.  Please refer ./phy.txt for the format.
38   - reg: The ID number for the phy.
41 - status: Should be "ok" or "disabled" for enabled/disabled. Default is "ok".
42 - tx-delay: Delay value for RGMII bridge TX clock.
46 - rx-delay: Delay value for RGMII bridge RX clock.
50 - rxlos-gpios: Input gpio from SFP+ module to indicate availability of
56 		compatible = "apm,xgene-device-clock";
57 		clock-output-names = "menetclk";
61 	menet: ethernet@17020000 {
62 		compatible = "apm,xgene-enet";
67 		reg-names = "enet_csr", "ring_csr", "ring_cmd";
69 		port-id = <0>;
71 		local-mac-address = [00 01 73 00 00 01];
72 		phy-connection-type = "rgmii";
73 		phy-handle = <&menetphy>;
75 			compatible = "apm,xgene-mdio";
76 			#address-cells = <1>;
77 			#size-cells = <0>;
79 				compatible = "ethernet-phy-id001c.c915";
86 /* Board-specific peripheral configurations */
88 	tx-delay = <4>;
89 	rx-delay = <2>;