Lines Matching +full:mmc +full:-

1 * Spreadtrum SDHCI controller (sdhci-sprd)
4 for MMC, SD and SDIO types of cards.
6 This file documents differences between the core properties in mmc.txt
7 and the properties used by the sdhci-sprd driver.
10 - compatible: Should contain "sprd,sdhci-r11".
11 - reg: physical base address of the controller and length.
12 - interrupts: Interrupts used by the SDHCI controller.
13 - clocks: Should contain phandle for the clock feeding the SDHCI controller
14 - clock-names: Should contain the following:
15 	"sdio" - SDIO source clock (required)
16 	"enable" - gate clock which used for enabling/disabling the device (required)
17 	"2x_enable" - gate clock controlling the device for some special platforms (optional)
20 - assigned-clocks: the same with "sdio" clock
21 - assigned-clock-parents: the default parent of "sdio" clock
22 - pinctrl-names: should be "default", "state_uhs"
23 - pinctrl-0: should contain default/high speed pin control
24 - pinctrl-1: should contain uhs mode pin control
33 - sprd,phy-delay-legacy: Delay value for legacy timing.
34 - sprd,phy-delay-sd-highspeed: Delay value for SD high-speed timing.
35 - sprd,phy-delay-sd-uhs-sdr50: Delay value for SD UHS SDR50 timing.
36 - sprd,phy-delay-sd-uhs-sdr104: Delay value for SD UHS SDR50 timing.
37 - sprd,phy-delay-mmc-highspeed: Delay value for MMC high-speed timing.
38 - sprd,phy-delay-mmc-ddr52: Delay value for MMC DDR52 timing.
39 - sprd,phy-delay-mmc-hs200: Delay value for MMC HS200 timing.
40 - sprd,phy-delay-mmc-hs400: Delay value for MMC HS400 timing.
41 - sprd,phy-delay-mmc-hs400es: Delay value for MMC HS400 enhanced strobe timing.
46 	compatible  = "sprd,sdhci-r11";
50 	clock-names = "sdio", "enable";
53 	assigned-clocks = <&ap_clk CLK_EMMC_2X>;
54 	assigned-clock-parents = <&rpll CLK_RPLL_390M>;
56 	pinctrl-names = "default", "state_uhs";
57 	pinctrl-0 = <&sd0_pins_default>;
58 	pinctrl-1 = <&sd0_pins_uhs>;
60 	sprd,phy-delay-sd-uhs-sdr104 = <0x3f 0x7f 0x2e 0x2e>;
61 	bus-width = <8>;
62 	non-removable;
63 	no-sdio;
64 	no-sd;
65 	cap-mmc-hw-reset;